156-836 無料問題集「CheckPoint Check Point Certified Maestro Expert - R81 (CCME)」

（A）A bond interface is used for passing synchronization traffic between the SGMs.

（B）A bond interface can be configured for high availability redundancy.

（C）A bond interface can be configured for high availability redundancy or for load sharing which increases connection throughput above that which is possible using one physical interface.

（D）For load sharing which increases connection throughput above that which is possible using one physical interface.

（A）Port 1 in Slot 2 and Port 2 in Slot 1

（B）This configuration is not supported

（C）Any pair of available ports

（D）Port 1 in Slot 1 and Port 2 in Slot 1

（A）The first MHO configured is considered the SMO Master.

（B）The MDS that pushes policy to the SMO is considered the SMO Master.

（C）The SGM with the lowest member ID (the first one added to the security group.)

（D）The SGM with the highest member ID (the last one added to the security group.)

（A）SFP+, SFP28, QSFP

（B）QSFP, QSFP28

（C）SFP, SFP+, SFP28

（D）SFP, QSFP, QSFP28

（A）Port 1 in Slot 2 and Port 2 in Slot 1

（B）Any pair of available ports

（C）Port 1 in Slot 1 and Port 1 in Slot 2

（D）Port 1 in Slot 1 and Port 2 in Slot 1

（A）Reserved for internal purposes. Not in use

（B）1Gbps connectivity for Security Groups

（C）Out-of-band interface for access to Orchestrator itself and Serial Console connector

（D）Two Out-of-band interfaces for access to Orchestrator itself

（A）50%/50%

（B）33%/66%

（C）66%/33%

（D）100%/0%

（A）SecureXL is not enabled on the SGM.

（B）An administrator imported a hotfix into the CPUSE repository of a single SGM.

（C）A change was made with clish instead of gClish, causing the SGM to handle traffic differently than the other SGMs.

（D）There are too many active SGMs in the SG.

（A）Active / Backup

（B）Active / Standby

（C）Load Sharing Active / Active

（D）VSLS