DC0-200 無料問題集「Dell Certified Server Professional」

（A）verify the SNMP settings of the new server

（B）install Dell OpenManage Remote Access Controller on the new server

（C）install Dell OpenManage Managed System applications on the new server

（D）install Dell OpenManage Management Station application on the new server

（E）ensure that the new server's IP address is in the discovery specified for OpenManage IT
Assistant

（A）IT Assistant

（B）Server Administrator

（C）Server Assistant

（D）Remote Access Controller

（A）remove the hard drives

（B）disconnect the RAID key

（C）disconnect the RAID cable

（D）disconnect the RAID battery

（A）PERC BIOS

（B）CERC BIOS

（C）Array Manager

（D）system setup

（A）12

（B）15

（C）9

（D）6

（A）boot to the Dell Server Assistant CD first

（B）NVRAM cannot be cleared once it has been set by an administrator.

（C）press F10 when prompted at startup

（D）in the System Setup utility, activate the Num Lock, Caps Lock, and Scroll Lock lights on the keyboard, then press Alt-E

（A）system software

（B）BIOS

（C）host bus adapter firmware

（D）Remote Access Controller firmware

（A）It saves a configuration as an executable file.

（B）It is only available in Windows 2000.

（C）It is used to install and configure the Broadcom Ethernet Controller driver.

（D）It lets you transfer teaming configurations to other servers.

（A）You specify the desired card for all outgoing traffic for the team. The other members will still accept incoming packets.

（B）You specify which adaptor will take the entire load. The other NICs will be used only when the Preferred Primary fails.

（C）You specify the desired card for all incoming traffic for the team. The other members will still transmit outgoing packets.

（D）You specify which adaptor will take the load until it is saturated, then the other members will start accepting packets until the Preferred Primary is just below the saturation point.

（A）1

（B）4

（C）2

（D）8