Senior-Internal-Corrosion-Technologist無料問題集「AMPP Internal Corrosion for Pipelines

質問 1

The coating applicator has ignored a surface preparation hold point and applied coating over the surface without a sign off from you as the inspector.
Your FIRST preferred course of action is to:

（A）Advise the Owner and write a Non-Conformance report

（B）Ignore the situation

（C）Require the Applicator to remove the applied coating

（D）Stop the Job

正解：A 解答を投票する

質問 2

You are the NACE Coating Inspector ona tank lining project where desiccant dehumidificationis being used.
Since the first shift ofabrasive Wasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

（A）Advise the coating applicator supervisor of your readings

（B）Document the readings at the end of the shift

（C）Call your supervisor

（D）Check to see if the dehumidification equipment is operating correctly

正解：A 解答を投票する

質問 3

Measuring methyl ethyl ketone (MEK) resistance of ethyl silicate Inorganic zinc-rich primers by solvent rub requires

（A）25 single rubs with a saturated cloth.

（B）25 double rubs with a saturated cloth.

（C）50 double rubs with a saturated cloth.

（D）35 single rubs with a saturated cloth.

正解：C 解答を投票する

質問 4

When environmental enclosures ate being used an inspector needs to be concerned about:

（A）Lighting

（B）Air changes

（C）Structural integrity

（D）a), b), and c)

正解：D 解答を投票する

質問 5

A failure caused by applying a coating too thinly is known as

（A）cracking.

（B）pinholes.

（C）chalking.

（D）failure to cure.

正解：B 解答を投票する

質問 6

Differences in technique for abrasive blasting concrete versus steel require the operator to:

（A）a), b) and c)

（B）Move the nozzle quicker

（C）Increase the standoff distance

（D）Lower the blast pressure

正解：A 解答を投票する

質問 7

Galvanizing performs best in which of the following exposures:

（A）pH below 4

（B）pH of 13

（C）pH above 12

（D）pH between 5-10

正解：D 解答を投票する

質問 8

The solvent sensitivity/solvent wipe test (ASTM D4752) is used to determine the cute of

（A）powder coatings.

（B）inorganic zincs.

（C）urethanes.

（D）epoxies.

正解：B 解答を投票する

Senior-Internal-Corrosion-Technologist 無料問題集「AMPP Internal Corrosion for Pipelines - Level 2」

弊社を連絡する

関連リンク

トップ試験