1Y0-350無料問題集「Citrix NetScaler 10 Essentials and Networking」

質問 1

A network engineer wants to optimize a published load balanced SSL virtual server for WAN connection with long delay, high bandwidth with minimal packet drops.
What would the network engineer use to do this type of optimization for the SSL virtual server?

（A）SSL policy

（B）Priority queuing policy

（C）Compression policy

（D）TCP profile

正解：D 解答を投票する

質問 2

Which two response codes and pages can be cached on the NetScaler using Integrated Caching? (Chose two.)

（A）401 Unauthorized

（B）500 Internal server error

（C）400 Bad request

（D）302 Found pages

（E）404 Not found pages

正解：D、E 解答を投票する

質問 3

Scenario: A network engineer has configured an HTTP application to be load balanced using a virtual server named Svr1. Users have reported intermittent errors and the engineer has been given the client IP address of an affected user and asked to determine which back end service they are connected to.
Using the command-line interface, how could the engineer find this information?

（A）Show lb vServer Svr1 -Summary

（B）Show system session

（C）Show lb persistentSessions Svr1

（D）Show lb vServer Svr1

正解：C 解答を投票する

質問 4

Scenario: An engineer executes the following commands:
add vlan 2
bind vlan 2 -ifnum 1/2
add ns ip 10.110.4.200 255.255.255.0
bind vlan 2 -IPAddress 10.110.4.200 255.255.255.0
What type of IP address has been added to the NetScaler?

（A）SNIP address

（B）GSLB Site IP address

（C）NSIP address

（D）VIP address

正解：A 解答を投票する

質問 5

Scenario: A network engineer has configured a load balancing virtual server for an HTTP application. Due to the application architecture, it is imperative that a user's session remains on a single server during the session. The session has an idle timeout of 60 minutes. Some devices are getting inconsistent application access while most are working fine. The problematic devices all have tighter security controls in place.
Which step should the engineer take to resolve this issue?

（A）Utilize SSL offload to enable the application to use SSL.

（B）Configure a backup persistence of SourceIP.

（C）Change the HTTP parameters to Cookie Version 1.

（D）Set the cookie timeout to 60 minutes.

正解：B 解答を投票する

質問 6

A network engineer wants to hide the IP address of the outgoing packets by changing it to the IP of the VIP.
Which feature should the administrator use?

（A）PBR

（B）RNAT

（C）Rewrite

（D）ACL

正解：B 解答を投票する

質問 7

Scenario: A network engineer suspects that there is a duplex mismatch in the network configuration. The NSIP address is 10.10.1.206.
How can the administrator verify the configuration in this scenario?

（A）Run the start nstrace -level 10 command.

（B）Check for the interface configuration in the GUI.

（C）Run the 'netstat -r' command.

（D）Run the show IP 10.10.1.206 command.

正解：B 解答を投票する

質問 8

When binding a certificate to a virtual server, which two certificate formats are supported by NetScaler? (Choose two.)

（A）PFX

（B）P7B

（C）PEM

（D）DER

正解：C、D 解答を投票する

質問 9

A network engineer should use the Advanced tab when configuring load balancing to enable __________. (Choose the correct option to answer the question.)

（A）EdgeSight Monitoring

（B）SSL offloading

（C）Direct Server Return Mode

（D）Integrated caching

正解：C 解答を投票する

質問 10

Some SSL certificate files may be missing from a NetScaler appliance.
Which directory should an engineer check to determine which files are missing?

（A）/nsconfig/ssl

（B）/var/netscaler/ssl/

（C）/nsconfig/ssh

（D）flash/nsconfig/

正解：A 解答を投票する

1Y0-350 無料問題集「Citrix NetScaler 10 Essentials and Networking」

弊社を連絡する

関連リンク

トップ試験