200-355 無料問題集「Cisco Implementing Cisco Wireless Network Fundamentals」

（A）Predictive survey

（B）Ekahau site survey

（C）Actual survey

（D）Airmagnet survey

（E）Passive survey

（F）Active survey

（A）Monitor

（B）SE-Connect

（C）Rogue detector

（D）Sniffer

（E）Local

（F）bridge

（G）FlexConnect

（A）WLC

（B）Prime Infrastructure

（C）Lightweight access point

（D）MSE

（A）Cisco unified wireless controller supports a maximum of one LAG, but switches support multiple EtherChannels.

（B）Cisco Unified wireless controller supports a maximum one LAG, and switches supports one EtherChannels per switch.

（C）Cisco Unified wireless controller supports multiple LAGs, and switches support multiple EtherChannels.

（D）Cisco Unified wireless controller supports a maximum of two LAG, but switches supports multiple EtherChannels.

（A）Identify and monitor rogue APs in the environment.

（B）Generate a list of interference reports.

（C）Capture and save RF traffic to analyze it offline.

（D）Detect and measure RF energy on a frequency.

（A）Cisco 5508 WLC

（B）Cisco Wireless LAN controller module for Cisco integrated services routers

（C）Cisco 2504 WLC

（D）Cisco 7500 WLC

（E）Cisco virtual wireless controller

（A）The Cisco WLC must be configured to allow wireless client management access

（B）The Cisco WLC does not allow wireless client management access.

（C）The wireless client can be used only for downloads or uploads to or from the Cisco WLC.

（D）The wireless client always has management access to the Cisco WLC.

（A）Defined DSSS and FHSS as possible methods for modulation.

（B）The most common deployment is 6 non-overlapping channels that are 20 MHz wide.

（C）Defined FIHSS and OFHM as possible methods for modulation

（D）Designed to operate in the 5 GHz ISM frequency spectrum.

（E）The most common deployment is three non-overlapping channels that are 20 MHz wide

（A）SE-connect mode

（B）Local mode

（C）H-reap mode

（D）Monitor mode

（A）Scattering

（B）Absorption

（C）Fading

（D）Multipath

（A）2*3:4

（B）4*3:2

（C）2*4:3

（D）3*4:2