300-135 無料問題集「Cisco Troubleshooting and Maintaining Cisco IP Networks (TSHOOT)」
Topology with three switches which are connected to each other via Gi0/0 & Gi0/1. All interfaces are configured in VLAN 100 and voice VLAN 101. Duplex mismatch between two switches (one interface in full duplex which the opposite interface in half duplex). Spanning tree is detecting a loop in the network, what is causing the loop.
正解:B
解答を投票する
The implementation group has been using the test bed to do an IPv6 'proof-of-concept1. After several changes to the network addressing and routing schemes, a trouble ticket has been opened indicating that the loopback address on R1 (2026::111:1) is not able to ping the loopback address on DSW2 (2026::102:1).
Use the supported commands to isolate the cause of this fault and answer the following question.
On which device is the fault condition located?
Use the supported commands to isolate the cause of this fault and answer the following question.
On which device is the fault condition located?
正解:G
解答を投票する
解説: (JPNTest メンバーにのみ表示されます)
