300-410無料問題集「Cisco Implementing Cisco Enterprise Advanced Routing and Services」

質問 1

Refer to the exhibit. Which configuration resolves the issue?

（A）

（B）

（C）

（D）

正解：B 解答を投票する

質問 2

Refer to the exhibit. Users on a call center report that they cannot browse the internet on Saturdays during the afternoon. Which configuration resolves the issue?

（A）

（B）

（C）

（D）

正解：B 解答を投票する

質問 3

Refer to the exhibit.

AS65510 iBGP is configured for directly connected neighbors. R4 cannot ping or traceroute network 192
168.100.0/24 Which action resolves this issue?

（A）Configure R4 as a route reflector server and configure R2 and R3 as route reflector clients.

（B）Configure R4 as a route reflector server and configure R1 as a route reflector client

（C）Configure R1 as a route reflector server and configure R2 and R3 as route reflector clients

（D）Configure R1 as a route reflector server and configure R4 as a route reflector client

正解：D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 4

Which protocol does VRF-Lite support?

（A）ODR

（B）IS-IS

（C）EIGRP

（D）IGRP

正解：C 解答を投票する

質問 5

Refer to the exhibit. A network engineer receives a report that Spoke 1 users can perform bank transactions with the server located at the Center site, but Spoke 2 users cannot. Which action resolves the issue?

（A）Configure encapsulation dot1q 78 on the router C interface.

（B）Configure IPv6 on the routers B and C interfaces

（C）Configure the Spoke 2 users IP on the router B OSPF domain

（D）Configure OSPFv2 on the routers B and C interfaces

正解：B 解答を投票する

質問 6

What is an advantage of using BFD?

（A）It has sub-second failure detection for layer 1 and layer 2 problems.

（B）It has sub-second failure detection for layer 1 and layer 3 problems.

（C）It detects local link failure at layer 2 and updates routing protocols.

（D）It detects local link failure at layer 1 and updates routing table.

正解：A 解答を投票する

質問 7

Which function does LDP provide in an MPLS topology?

（A）It enables a MPLS topology to connect multiple VPNs to P routers.

（B）It provides hop-by-hop forwarding in an MPLS topology for LSRs.

（C）It provides a means for LSRs to exchange IP routes.

（D）It exchanges routes for MPLS VPNs across different VRFs.

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 8

A customer requested a GRE tunnel through the provider network between two customer sites using loopback to hide internal networks. Which configuration on R2 establishes the tunnel with R1?

（A）R2(config)# interface Tunnel 1R2(config-if)# ip address 172.20.1.2 255.255.255.0R2(config-if)# ip mtu 1400R2(config-if)# ip tcp adjust-mss 1360R2(config-if)# tunnel source 192.168.20.1R2(config-if)# tunnel destination 192.168.10.1

（B）R2(config)# interface Tunnel 1R2(config-if)# ip address 172.20.1.2 255.255.255.0R2(config-if)# ip mtu 1500R2(config-if)# ip tcp adjust-mss 1360R2(config-if)# tunnel source 192.168.20.1R2(config-if)# tunnel destination 10.10.1.1

（C）R2(config)# interface Tunnel 1R2(config-if)# ip address 172.20.1.2 255.255.255.0R2(config-if)# ip mtu 1500R2(config-if)# ip tcp adjust-mss 1360R2(config-if)# tunnel source 10.10.2.2R2(config-if)# tunnel destination 10.10.1.1

（D）R2(config)# interface Tunnel 1R2(config-if)# ip address 172.20.1.2 255.255.255.0R2(config-if)# ip mtu 1400R2(config-if)# ip tcp adjust-mss 1360R2(config-if)# tunnel source 10.10.2.2R2(config-if)# tunnel destination 10.10.1.1

正解：C 解答を投票する

質問 9

Refer to me exhibit. The hub and spoke are connected via two DMVPN tunnel interfaces The NHRP is configured and the tunnels are detected on the hub and the spoke Which configuration command adds an IPsec profile on both tunnel interfaces to encrypt traffic?

（A）tunnel protection ipsec profile DMVPN multipoint

（B）tunnel protection ipsec profile DMVPN tunnel1

（C）tunnel protection ipsec profile DMVPN unique

（D）tunnel protection ipsec profile DMVPN shared

正解：D 解答を投票する

質問 10

Refer to the exhibit.

An engineer must establish multipoint GRE tunnels between hub router R6 and branch routers R1, R2, and R3. Which configuration accomplishes this task on R1?

（A）

（B）

（C）

（D）

正解：D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 11

A company is expanding business by opening 35 branches over the Internet. A network engineer must configure DMVPN at the branch routers to connect with the hub router and allow NHRP to add spoke routers securely to the multicast NHRP mappings automatically Which configuration meets this requirement at the hub router?

（A）

（B）

（C）

（D）

正解：D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 12

Drag and Drop the IPv6 First-Hop Security features from the left onto the definitions on the right.

正解：

Explanation:
Graphical user interface, chart Description automatically generated

質問 13

What is the output of the following command:
show ip vrf

（A）Show's routing protocol information associated with a VRF.

（B）Show's default RD values

（C）Displays the ARP table (static and dynamic entries) in the specified VRF

（D）Displays IP routing table information associated with a VRF

正解：B 解答を投票する

質問 14

:593

Refer to the exhibit. Which two configurations are required on R2 to prevent a routing loop caused by the redistribution from OSPF back into EIGRP? (Choose two.)

（A）Option E

（B）Option D

（C）Option B

（D）Option C

（E）Option A

正解：B、D 解答を投票する

質問 15

Refer to the exhibit. An engineer configured user login based on authentication database on the router, but no one can log into the router. Which configuration resolves the issue?

（A）aaa authorization network default local

（B）aaa authentication login default local

（C）aaa authentication login default enable

（D）aaa authorization exec default local

正解：B 解答を投票する

質問 16

Refer to the exhibit.

An administrator configures a router to stop using a particular default route if the DNS server 8.8.8.8 is not reachable through that route. However, this configuration did not work as desired and the default route still works even if the DNS server 8.8.8 8 is unreachable. Which two configuration changes resolve the issue?
(Choose two.)

（A）Use a separate IP SLA probe and track object for every static route

（B）Configure two static routes for the 8.8.8.8/32 destination to match the IP SLA probe for each ISP.

（C）Associate every IP SLA probe with the proper WAN address of the router.

（D）Reference the proper exit interfaces along with the next hops in both static default routes.

（E）Use a separate track object to reference the existing IP SLA 1 probe for every static route.

正解：A、B 解答を投票する

質問 17

The network administrator is tasked to configure R1 to authenticate telnet connections based on Cisco ISE using RADIUS. ISE has been configured with an IP address of 192.168.1.5 and with a network device pointing towards R1 (192.168.1.1) with a shared secret password of Cisco123. If ISE is down, the administrator should be able to connect using the local database with a username and password combination of admin/cisco123.
The administrator has configured the following on R1:

ISE has gone down. The Network Administrator is not able to Telnet to R1 when ISE went down. Which two configuration changes will fix the issue? (Choose two.)

（A）Option E

（B）Option D

（C）Option B

（D）Option C

（E）Option A

正解：A、D 解答を投票する

質問 18

An engineer configured policy-based routing for a destination IP address that does not exist in the routing table. How is the packet treated through the policy for configuring the set ip default next-hop command?

（A）Packets are not forwarded to the specific next hop.

（B）Packets are forwarded to the specific next hop.

（C）Packets are forwarded based on a static route.

（D）Packets are forwarded based on the routing table.

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

300-410 無料問題集「Cisco Implementing Cisco Enterprise Advanced Routing and Services」

弊社を連絡する

関連リンク

トップ試験