次の認定試験に速く合格する！

簡単に認定試験を準備し、学び、そして合格するためにすべてが必要だ。

会員センターカート (0)

300-430 無料問題集「Cisco Implementing Cisco Enterprise Wireless Networks」

ページ: 1 / 15
トータル 281 問

サインアップ、ログインされた後に、試験全体を無料で表示できるようになります。

質問 1

A corporation has employees working from their homes. A wireless engineer must connect 1810 OEAP at remote teleworker locations. All configuration has been completed on the controller side, but the network readiness is pending. Which two configurations must be performed on the firewall to allow the AP to join the controller? (Choose two.)

（A）Allow UDP ports 12222 and 12223 on the firewall.

（B）Allow UDP ports 5246 and UDP port 5247 on the firewall.

（C）Enable NAT Address on the 5520 with an Internet-routable IP address.

（D）Block UDP ports 1812 and 1813 on the firewall.

（E）Configure a static IP on the OEAP 1810.

正解：A、B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 2

An enterprise has two WLANs configured on WLC. It is reported that when converting APs to FlexConnect mode. WLAN A works but WLAN B does not. When converting APs to local mode.
WLAN B works, but WLAN A does not. Which action is needed to complete this configuration?

（A）Join the APs to a Cisco FlexConnect group.

（B）Disable local switching on the WLANs.

（C）Create a Cisco FlexConnect group with WLAN-VLAN mapping.

（D）Map the AP group to the WLAN interface.

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 3

An engineer is considering an MDM integration with Cisco ISE to assist with security for lost devices.
Which two functions of MDM increase security for lost devices that access data from the network? (Choose two.)

（A）Jailbreak/root detection

（B）data wipe

（C）data encryption

（D）PIN enforcement

（E）data loss prevention

正解：B、D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 4

Refer to the exhibit. A wireless engineer has integrated the wireless network with a RADIUS server. Although the configuration on the RADIUS is correct, users are reporting that they are unable to connect. During troubleshooting, the engineer notices that the authentication requests are being dropped. Which action will resolve the issue?

（A）Configure the shared-secret keys on the controller and the RADIUS seever.

（B）Allow connectivity from the wireless controller to the IP of the RADIUS server.

（C）Authenticate the client using the same EAP type that has been set up on the RADIUS server.

（D）Provide a valid client username that has been configured on the RADIUS server

正解：A 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 5

What is an important consideration when implementing a dual SSID design for BYOD?

（A）SSIDs for this setup must be configured with NAC State-RADIUS NAC for the clients to authenticate with Cisco ISE, or with NAC State-ISE NAC for Cisco ISE to associate the client.

（B）One SSID is for provisioning and the other SSID is for gaining access to the network. The use of an ACL should not be enforced to make the client connect to the REAL SSID after provisioning.

（C）If multiple WLCs are used, the WLAN IDs must be exact for the clients to be provisioned and traverse the network correctly.

（D）After using the provisioning SSID, an ACL that used to make the client switch SSIDs forces the user to associate and traverse the network by MAC filtering.

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 6

An engineer needs to configure an autonomous AP for 802.Ix authentication. To achieve the h ghest security an authentication server is used for user authentication During testing, the AP fails to pass the user authentication request to the authentication server. Which two details need to be configured on the AP to allow communicator! between the server and the AP? (Choose two.)

（A）Group name

（B）PAC encryption key

（C）RADIUS IP address

（D）Shared secret

（E）Username and password

正解：C、D 解答を投票する

質問 7

Which two steps are needed to complete integration of the MSE to Cisco Prime Infrastructure and be able to track the location of clients/rogues on maps? (Choose two.)

（A）Synchronize access points with the MSE.

（B）Add the MSE to Cisco Prime Infrastructure using the Cisco Prime Infrastructure communication credentials configured during set up.

（C）Apply a valid license for location tracking.

（D）Apply a valid license for Wireless Intrusion Prevention System.

（E）Add the MSE to Cisco Prime Infrastructure using the CLI credentials.

正解：B、C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 8

An engineer attempts to troubleshoot client connectivity issues in Cisco Prime Infrastructure. The Cisco Prime Infrastructure GUI is performing as expected, but the client detail information that is displayed is not current. The displayed client state and connected AP are up to 5 minutes old.
Which action resolves this issue?

（A）Change the data retention settings to 5 seconds.

（B）Enable client Assoc/Disassoc and Auth/Deauth SNMP traps on the controller.

（C）Optimize the Cisco Prime Infrastructure database.

（D）Use a different browser to access the web interface.

正解：C 解答を投票する

質問 9

After the rogue reports from Cisco Prime Infrastructure are reviewed, it is determined that the automatic rogue mitigation is not working as planned. Which security measure must be taken to help prevent rogue APs from being plugged into the network?

（A）Apply an IP access list to ports.

（B）Apply port security to the switch.

（C）Apply a different version of spanning tree.

（D）Add a MAC filter to the switch.

正解：B 解答を投票する

質問 10

A wireless network engineer must present a list of all rogue APs with a high severity score to senior management.
Which report must be created in Cisco Prime Infrastructure to provide this information?

（A）Rogue AP Events

（B）New Rogue APs

（C）Rogue AP Count Summary

（D）Rogue APs

正解：D 解答を投票する

質問 11

A customer is experiencing performance issues with its wireless network and asks a wireless engineer to provide information about all sources of interference and their impacts to the wireless network over the past few days.
Where can the requested information be accessed?

（A）CleanAir reports on Cisco Prime Infrastructure

（B）Air Quality reports on Cisco Wireless LAN Controller

（C）Interference Devices reports on Cisco Wireless LAN Controller

（D）Performance reports on Cisco Prime Infrastructure

正解：A 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 12

What is the maximum time range that can be viewed on the Cisco DNA Center issues and alarms page?

（A）7 days

（B）3 hours

（C）3 days

（D）24 hours

正解：A 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 13

Refer to the exhibit. An ACL is configured to restrict access for BYOD clients. The ACL must redirect devices to the guest portal. To which two devices on the local network must the ACL allow access other than the DHCP server? (Choose two.)

（A）WLC

（B）Cisco ISE

（C）RADIUS server

（D）DNS server

（E）SNMP server

正解：B、D 解答を投票する

質問 14

A wireless administrator receives this information to complete a CMX deployment in high availability by using version 10.6 to gather analytics.
- IP address of the primary server
- IP address of the secondary server
- failover mode to be configured as automatic
- root password of the secondary server
- email ID for NOC notifications
Enabling high availability fails when these parameters are used. Which action resolves the issue?

（A）Place primary and secondary servers in different subnets.

（B）Enable the virtual IP address of the primary server.

（C）Insert the cmxadmin password of the secondary server.

（D）Use IP protocol 4242 for the controller to reach the CMX server.

正解：C 解答を投票する

質問 15

An engineer must configure a Cisco WLC to support Cisco Aironet 600 Series OfficeExtend APs.
Which two Layer 2 security options are supported in this environment? (Choose two.)

（A）CKIP

（B）802.1X

（C）Static WEP

（D）Static WEP + 802.1X

（E）WPA+WPA2

正解：C、E 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 16

An engineer is troubleshooting rogue access points that are showing up in Cisco Prime Infrastructure.
What is maximum number of APS the engineer can use to contain an identified rogue access point in the WLC?

（A）3

（B）5

（C）4

（D）6

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 17

An engineer is implementing Cisco Identity-Based Networking on a Cisco AireOS controller. The engineer has two ACLs on the controller.
The first ACL, named BASE_ACL, is applied to the corporate_clients interface on the WLC, which is used for all corporate clients.
The second ACL, named HR_ACL, is referenced by ISE in the Human Resources group policy.
What is the resulting ACL when a Human Resources user connects?

（A）HR_ACL appended with BASE_ACL

（B）HR_ACL only

（C）BASE_ACL only

（D）BASE_ACL appended with HR_ACL

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 18

A wireless engineer must configure IEEE 802.1X authentication on a WLAN that supports new and legacy wireless devices. Which condition must be met for the legacy clients to be able to associate and authenticate without issues?

（A）The client and the authenticator must support the same authentication protocol.

（B）The authenticator and the authentication server must support the same authentication protocol.

（C）The client and the controller must support the same authentication protocol.

（D）The client and the authentication server must support the same authentication protocol.

正解：A 解答を投票する

質問 19

Where is a Cisco OEAP enabled on a Cisco Catalyst 9800 Series Wireless Controller?

（A）AP Join Profile

（B）Flex Profile

（C）Policy Profile

（D）RF Profile

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

ページ: 1 / 15
トータル 281 問

300-430 の機能をすべて解除する

キャプチャ不要
365日無料更新サービス
希望する合格率を設定できる
時間の割り当てられる（時間：分）
300-430 に2つの練習用モード
サポートサービス対応

完全版を入手する

弊社を連絡する

我々は１２時間以内ですべてのお問い合わせを答えます。

オンラインサポート時間：( UTC+9 ) 9:00-24:00
月曜日から土曜日まで

サポート：現在連絡

トップ試験

2V0-32.24 試験問題集
350-401 試験問題集
300-410 試験問題集
API-580 試験問題集
E_S4HCON2023 試験問題集
SC-400 試験問題集

300-430 無料問題集「Cisco Implementing Cisco Enterprise Wireless Networks」

弊社を連絡する

関連リンク

トップ試験