300-625無料問題集「Cisco Implementing Cisco Storage Area Networking」

質問 1

A storage administrator wants to enable NPV in a Fibre Channel edge switch.
Which configuration is supported in this mode?

（A）Dynamic Port VSAN Membership

（B）Cisco Fabric Services distribution over Fibre Channel

（C）E Port connectivity to the core switch

（D）local switching of east-west traffic

正解：B 解答を投票する

質問 2

The principal switch on a Fibre Channel network fails to assign requested domain to a subordinate switch. What are two reasons? (Choose two.)

（A）The requested domain is outside the allowed list.

（B）An existing switch already has the requested domain assigned.

（C）Cisco Fabric Services distribution is not enabled on the switch.

（D）The persistent FC ID feature is not enabled.

（E）The fabric is locked.

正解：A、B 解答を投票する

質問 3

Refer to the exhibit. A network engineer must configure the SAN telemetry streaming feature to stream statistics form a Cisco MDS 9000 Series Switch to two external receivers with the IP addresses 192.168.1.4 and 192.168.1.5.
Which two configurations accomplish this configuration? (Choose two.)

（A）Add dst-grp 300 under subscription 200.

（B）Add dst-grp 200 under subscription 100.

（C）Add IP address 192.168.1.5 port 50005 protocol gRPC encoding GPB under destination-group
300.

（D）Add dst-grp 100 under subscription 200.

（E）Add IP address 192.168.1.5 port 50005 protocol gRPC encoding GPB under destination-group
100.

正解：B、E 解答を投票する

質問 4

A storage administrator is connecting two previously configured switches to make a single fabric.
When the E Ports are connected, the administrator sees a ZONE MERGE FAILURE message referring to the zoneset for VSAN 10 on each switch.
Which command should the administrator use to allow these switches to work together?

（A）zoneset copy active-zoneset full-zoneset

（B）zoneset distribute full vsan 10

（C）zoneset import interface fc1/1 vsan 10

（D）zoneset overwrite-control vsan 10

正解：C 解答を投票する

質問 5

Refer to the exhibit. Which command is used to determine which switch has the lock?

（A）show flogi database

（B）show fcs ie vsan

（C）show zone status

（D）show zoneset active

正解：C 解答を投票する

質問 6

Which statement accurately describes the result of disabling restrictions on oversubscription ratios on Cisco MDS 9000 Series Fibre Channel switching modules?

（A）A port-group can contain a single port only.

（B）QoS can be configured.

（C）The bandwidth allocated to shared ports is proportionate to the configured speed of the ports.

（D）The bandwidth allocation of the shared ports is equal to the lowest configured bandwidth.

正解：C 解答を投票する

質問 7

A storage network engineer is implementing SAN telemetry for a SAN infrastructure using Cisco DCNM for SAN. Which command is used to check the session status for telemetry operation?

（A）show telemetry pipeline stats

（B）show telemetry control stats

（C）show telemetry transport

（D）show analytics system-load

正解：C 解答を投票する

300-625 無料問題集「Cisco Implementing Cisco Storage Area Networking」

弊社を連絡する

関連リンク

トップ試験