350-601 無料問題集「Cisco Implementing Cisco Data Center Core Technologies (350-601 DCCOR)」
Drag and Drop Question
Refer to the exhibit. An engineer must configure NetFlow on the Cisco Nexus 9000 Series Switch for all traffic that arrives from the web server. Drag and drop the configuration steps from the right onto the blanks in the code on the left to complete the N9K-1 configuration. Not all configuration steps are used.
Refer to the exhibit. An engineer must configure NetFlow on the Cisco Nexus 9000 Series Switch for all traffic that arrives from the web server. Drag and drop the configuration steps from the right onto the blanks in the code on the left to complete the N9K-1 configuration. Not all configuration steps are used.
正解：
Refer to the exhibit. An engineer is troubleshooting a connectivity issue for a VM with MAC address 00:50:56:88:10:14 running on the Cisco UCS-B Series blade in VLAN 10. Cisco UCS Manager is connected to a Cisco Nexus 9000 Series switch over port channel 10. Currently, the VM is unreachable from any source that is outside of the Cisco UCS domain. Which action must be taken to allow the VM to be reachable?
正解：A
解答を投票する
解説: (JPNTest メンバーにのみ表示されます)
A network engineer must restore the running configuration on a Cisco Nexus 5000 Series Switch to an existing snapshot called "stable1". The restore procedure should proceed only if no errors occur. Which configuration should be used to accomplish this goal?
正解：A
解答を投票する
解説: (JPNTest メンバーにのみ表示されます)
Drag and Drop Question
Refer to the exhibit. An engineer implements a dynamically negotiated LACP port channel on SW1. The port channel members must be configured as active/standby ports with Eth1/2 as active and Eth1/1 as standby. The Eth1/1 interface is configured with default priority. Drag and drop the code snippets from the right onto the blanks in the code on the left to complete the Eth1/2 interface configuration for SW1. Not all code snippets are used.
Refer to the exhibit. An engineer implements a dynamically negotiated LACP port channel on SW1. The port channel members must be configured as active/standby ports with Eth1/2 as active and Eth1/1 as standby. The Eth1/1 interface is configured with default priority. Drag and drop the code snippets from the right onto the blanks in the code on the left to complete the Eth1/2 interface configuration for SW1. Not all code snippets are used.
正解：
