600-660無料問題集「Cisco Implementing Cisco Application Centric Infrastructure

質問 1

What is a use of the Overlay Multicast TEP in Cisco ACI Multi-Site communication?

（A）to send and receive unicast VXLAN data plane traffic

（B）to establish MP-BGP adjacencies with remote spines

（C）to act as the source IP for BUM traffic

（D）to perform headend replication

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 2

What are two characteristics of Cisco ACI interaction with MSTP? (Choose two.)

（A）The PVST simulation must be configured on external network switches to support MSTP.

（B）A static path binding is required for native VLAN to carry the MST BPDUs in existing EPGs.

（C）Mis-cabling protocol is used to snoop the MSTP TCN packets.

（D）A Cisco ACI leaf flushes all local endpoints in the received EPG when an MSTP TCN frame is received.

（E）A dedicated EPG must be created for the native VLAN ID with static bindings toward the MSTP-enabled switches.

正解：C、E 解答を投票する

質問 3

An existing Cisco ACI Multi-Site setup with default fabric settings contains endpoints that communicate with an MTU of 1500. What is the minimum MTU value that must be supported by the ISN to allow control plane endpoint information exchange between sites?

（A）9100

（B）1600

（C）1554

（D）9000

正解：A 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 4

Refer to the exhibit.

A network engineer configures a Layer 4 to Layer 7 device for an outside routed firewall that is connected to POD-1 inside a Cisco ACI fabric that consists of two pods. All traffic from POD-1 or POD-2 that uses the L3Out should pass through the routed firewall. Which Function Type must be implemented in the service graph for POD-2 to use L3Out?

（A）GoThrough

（B）L1

（C）L2

（D）GoTo

正解：C 解答を投票する

質問 5

Refer to the exhibit.

Between Cisco UCS Fls and Cisco ACI leaf switches, CDP is disabled, the LLDP is enabled, and LACP is in Active mode. Which two discovery protocols and load-balancing mechanism combinations can be implemented for the DVS? (Choose two.)

（A）CDP enabled, LLDP disabled, and MAC Pinning

（B）CDP disabled, LLDP enabled, and MAC Pinning

（C）CDP enabled, LLDP enabled, and LACP Active

（D）CDP enabled, LLDP disabled, and LACP Passive

（E）CDP enabled, LLDP disabled, and LACP Active

（F）CDP disabled, LLDP enabled, and LACP Passive

正解：B、D 解答を投票する

質問 6

What are two characteristics of Cisco ACI and Spanning Tree Protocol interaction? (Choose two.)

（A）Cisco ACI must be configured as the STP root for all VLANs.

（B）BPDU filter and BPDU guard can be configured on Cisco ACI leaf edge ports.

（C）MST BPDUs are flooded correctly in Cisco ACI fabric without additional configuration.

（D）STP BPDUs are dropped due to MCP.

（E）When a TCN BPDU is received in a VLAN, Cisco ACI flushes the endpoints for the associated encapsulation.

正解：A、B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

600-660 無料問題集「Cisco Implementing Cisco Application Centric Infrastructure - Advanced (DCACIA)」

弊社を連絡する

関連リンク

トップ試験