6002 無料問題集「Avaya 6002.1 Avaya Aura(TM) Communication Manager and CM Messaging (R6.0) Implementation」

（A）Verify the hunt group status

（B）Perform message waiting indication test

（C）Check the messaging port status using the display port command

（D）Call the messaging Hunt Group

（E）Check the messaging port status using the status port command

（A）By going to the home page of console domain.

（B）By using the internet explorer http://Cdom .lpaddr/vm

（C）By going to the home page of Dom 0

（D）By going to the homepage of Avaya communication manager.

（A）From the laptop connected to the network, ping the dom0 IP address and verify a successful response.

（B）After connecting the server using PuTTY and logging in as root, verify there are no errors when running the xm list command.

（C）Immediately after the installation, verify the DVD is ejected from the drive and that the server reboots.

（D）From the system management console browser, verify domain-0 and cdom are running

（A）S8300C

（B）S8510

（C）S8800

（D）S8300D

（A）The installer used the wrong interface to install the license and it is therefore not installed.

（B）The license audit runs every 60 minutes and the error will be resolved in 15 minutes.

（C）The server cannot communicate with the IPSI or media gateway whose serial number was used in the license file.

（D）The installer loaded a license for one of the survivable servers, not the main server, and the IPSIs, media Gateways, and/or IP phones have registered to it

（A）New station 1000

（B）Add set 1000

（C）Add station 1000

（D）Build station 1000

（A）Set a static IP address on a laptop and see if the TN2602 Media Resource circuit pack can be pinged.

（B）Verify that the processor Ethernet mode is enabled in the Server.

（C）Set a static IP address on a laptop and see if the server can be pined

（D）Verify that the TN2602 Media resources circuit pack has the correct IP settings.