C_IBP_2211 無料問題集「SAP Certified Application Associate - SAP IBP for Supply Chain (2211)」

（A）All time levels available in the time profile

（B）Only time levels from the base planning level of selected key figures

（C）All time levels available in the time profile, restricted by global configuration parameter

（D）Only base time levels of the planning area

（A）SOURCELOCATION

（B）SOURCECUSTOMER

（C）SOURCEPRODUCTION

（D）SOURCECUSTGROUP

（A）The alerts dashboard is not available if a value-based filter is set for the open planning view.

（B）You can add (or delete) planning objects to a planning view after these filters are applied.

（C）These filters can be used together with attribute totals in the same planning view.

（D）You can only apply one value-based filter per planning view.

（E）These filters are always applied based on the values stored in the database.

（A）Display all assigned analytics on a single UI.

（B）Use drill-down functionality.

（C）Rename the charts.

（D）Add process templates.

（E）Link two analytics charts.

（A）Minimum lot size

（B）Aggregated constraints

（C）Maximum lot size

（D）Transportation lead times

（E）Adjusted transport receipts

（A）Specify a planning horizon in the planning area for each level of the assigned time profile.

（B）Configure at least one calculated key figure for the planning area.

（C）Configure at most two input key figures on the same planning level in a key figure calculation.

（D）Assign the compound master data type and its component master data types.

（A）A special key figure marked as an aggregate key figure (aggregate constraint)

（B）A unit of measure key figure, such as UOMCONVERSIONFACTOR

（C）A forecast metric key figure, such FCSTMAPE

（D）A currency conversion key figure, such as exchange rate

（A）Global cost factors

（B）Time profile level

（C）Processing mode

（D）Discretization