D-PST-OE-23 無料問題集「EMC Dell PowerStore Operate 2023」

（A）25 GigE Twinax

（B）10 GigE Cat 6 Ethernet RJ-45

（C）100 GigE QSFP28

（D）10 GigE SFP optical cable

（A）T systems have higher heat dissipation specifics than X systems

（B）Lower model numbered systems have lower heat dissipation specifications than higher model numbered systems

（C）Higher model numbered systems have lower heat dissipation specifications than lower model numbered systems

（D）X systems have higher heat dissipation specifics than T systems

（A）3

（B）1

（C）4

（D）2

（A）1 node with high availability enabled

（B）1 node with duel connectivity

（C）2 nodes configured as Active-Standby

（D）2 nodes configured as Active-Active

（A）Use package material to build "provisional ESD-Kit"

（B）If FRU does not contain ESD-Kit, continue without it

（C）Follow precautions described in the "Emergency Procedure"

（D）Order "Emergency ESD-Kit" ASAP

（A）Cluster has only a single appliance

（B）Base enclosure has a component hardware fault

（C）Appliance has a node in service mode

（D）Base enclosure hardware is operating normally

（A）The system is not initialized

（B）Nodes are in service mode

（C）The system is booting

（D）Nodes are in degraded mode

（A）3

（B）1

（C）4

（D）2

（A）sudo service

（B）svc_inject -root

（C）svc_inject generate-key --root

（D）su - root

（A）Additional VLTi links on the ToR switching must be configured for the 9000T to support the increased inter-switch network load

（B）Remove two of the four NVMe NVRAM drives from the 9000T the caching configuration of all clustered appliances must match

（C）Add the new 9000T appliance into the cluster per the procedure; mixed models of the same type are supported

（D）The new appliance cannot be added to the cluster; appliance model and type must match when clustering appliances together