H12-311-ENU無料問題集「Huawei Certified ICT Associate-Wireless Local Area Network」

質問 1

The MEth0/0/1 interface on the AC6605 is used for inband network management. The default address is 192.168.1.1/24 and cannot be modified.

（A）False

（B）True

正解：A 解答を投票する

質問 2

For better coverage, try to make the AP signal pass through the wall.

（A）Vertical

（B）45°

（C）60°

（D）Parallel

正解：A 解答を投票する

質問 3

What are the options that can be configured under sevice-set (Select 3 Answers)?

（A）can be bound to wmm-profile

（B）The SSID string can be configured via ssid xxxx

（C）Can call wlan-ess interface and configure service-vlan

（D）You can configure the forwarding mode as direct-forward or tunnel-forward

正解：B、C、D 解答を投票する

質問 4

Which technology is below the wireless metropolitan area network?

（A）WiMAX

（B）2G/3G

（C）WLAN

（D）Bluetooth

正解：C 解答を投票する

質問 5

The BSSID is actually the MAC address of the AP and is used to identify the BSS managed by the AP.

（A）False

（B）True

正解：A 解答を投票する

質問 6

For outdoor long-distance point-to-point backhaul, the antenna of should be selected.

（A）High gain, large lobe width

（B）High gain, small lobe width

（C）Omnidirectional

（D）Low gain, large lobe width

正解：B 解答を投票する

質問 7

When the AC is a side-by-side networking, if the data is directly forwarded, the data stream () AC; if the data is in tunnel forwarding mode, the data Stream AC.

（A）No pass, pass

（B）After passing through not

（C）After passing through

（D）No pass, no pass

正解：A 解答を投票する

質問 8

Which of the following options is the maximum rate supported by the 802.11g protocol?

（A）11Mbps

（B）22Mbps

（C）54Mbps

（D）108Mbps

正解：C 解答を投票する

質問 9

According to the following configuration example, the following statement is correct.
[AC] dhcp enable [AC] interface VLANif100
[AC-VLANif100] ip address 10.1.100.1 24
[AC-VLANif100] dhcp select interface
[AC-VLANif100] quit

（A）The DHCP service is enabled by default in the global mode, so the dhcp enable can be configured. The

（B）If VLAN 100 is a user VLAN, the gateway is 10.1.100.1 and the mask is 255.255.255.0 after the user receives the address.

（C）If VLAN 100 is the management VLAN where the AP is located, the option 43 field in the DHCP message received by the AP should be 10.1.100.1.

（D）dhcp select interface command enables the DHCP client function on the interface of VLAN 100.

正解：B 解答を投票する

質問 10

After a wireless user connects to a wireless signal point, they cannot obtain an IP address.
What are the possible reasons (Select 2 Answers)?

（A）wlan-ess virtual interface.

（B）The MAC address of the user device has been added to the blacklist.

（C）The user-specified authentication password is incorrect.

（D）The DHCP server is not configured in the VLAN where the user is located. The dhcp-enable command is not configured on the

正解：A、D 解答を投票する

質問 11

In the WDS peer-to-peer network, the backbone link between the Root AP and the Leaf AP is connected in the 5 GHz band. The bandwidth used by the Root AP is 149.
Which of the following bands should the Leaf AP use?

（A）149

（B）Except for 149

（C）153

（D）157

正解：A 解答を投票する

質問 12

There are three types of Huawei load balancing judgment: traffic mode, session mode, and virtual switch mode.

（A）False

（B）True

正解：A 解答を投票する

質問 13

The omnidirectional antenna exhibits a degree of on the horizontal pattern.

（A）360

（B）90

（C）180

（D）0

正解：A 解答を投票する

質問 14

What is the network consisting of a wireless AP and associated wireless clients?

（A）BSS

（B）ESS

（C）NSS

（D）IBSS

正解：A 解答を投票する

H12-311-ENU 無料問題集「Huawei Certified ICT Associate-Wireless Local Area Network」

弊社を連絡する

関連リンク

トップ試験