HP2-Z18無料問題集「HP Network Infrastructure AIS 2011」

質問 1

Which categories of routing protocols include RIP and OSPF? (Select two.)

（A）link state

（B）exterior gateway

（C）interior gateway

（D）label switching

（E）distance vector

正解：A、E 解答を投票する

質問 2

How is the first Telnet interface for A-Series switches identified in the CLI?

（A）interface aux 0

（B）interface remote

（C）interface com 0

（D）interface vty 0

正解：D 解答を投票する

質問 3

What is indicated by this entry in the IP route table of an HP E8212 zl switch?

（A）The switch has been configured with an ACL that blocks communications with the loopback interfaces.

（B）A loopback interface is configured with 127.0.0.0.

（C）Traffic to this interface is rejected with the single exception of traffic to the host address of the switch's loopback interface (127.0.0.1/ 32).

（D）The switch does not permit communications with any loopback interface.

正解：C 解答を投票する

質問 4

You must configure an HP E3500 yl switch for installation in a network that uses a mix of STP and RSTP. What must you do to ensure that the E3500 will interoperate with other switches in this Spanning Tree?

（A）Enter spanning-tree in the global configuration context.

（B）Enter spanning-tree conf ig-revision stp in the configuration context for every VLAN the switch shares with another switch.

（C）Enter spanning-tree force-version all-stp-operation in the global configuration context.

（D）Enter spanning-tree mode stp rstp in the configuration context of every port where the switch will hear Spanning Tree BPDUs.

正解：A 解答を投票する

質問 5

The output of show spanning-tree instance 3 on two HP E8212 zI Switches indicates that both switches are the Root of MST instance 3. What is an accurate explanation for this output?

（A）The switches are configured with the same Bridge Priority for the instance.

（B）The switches have the same MST configuration name

（C）The switches have different MST configuration revisions.

（D）The switches are running incompatible Spanning Tree Protocols.

正解：C 解答を投票する

質問 6

Which potential problem is addressed by BPDU Protection on HP A-Series switches?

（A）a technician accidentally inserting a switch running STP into an MSTP region

（B）a technician accidentally disrupting a Spanning Tree by connecting a switch to an edge port

（C）a technician accidentally configuring a switch to run PVST+ instead of MSTP

（D）a technician accidentally configuring two switches to be Root Bridge in an MSTP instance

正解：B 解答を投票する

質問 7

Which link aggregation protocol is supported by HP A-Series switches?

（A）Multi-Link Trunking (MLT)

（B）HP Port Trunking

（C）Link Aggregation Control Protocol (LACP)

（D）Port Aggregation Protocol (PAgP)

正解：C 解答を投票する

質問 8

What is the effect of the following command entered at the CLI of an HP A12500 switch?
[A12500] rip

（A）The CLI displays the RIP configuration.

（B）The administrator is prompted to enter "enable" or "disable."

（C）The CLI moves to the RIP view.

（D）RIP is enabled

正解：C 解答を投票する

質問 9

What is the default IRF priority setting on an HP A-Series switch?

（A）auto-assigned

（B）1

（C）32

（D）0

正解：C 解答を投票する

質問 10

You make configuration changes to the running configuration of your HP E3500 yI switch. Which command saves these changes to your startup configuration?

（A）write config

（B）save running-config

（C）copy running-config startup-config

（D）write memory

正解：D 解答を投票する

HP2-Z18 無料問題集「HP Network Infrastructure AIS 2011」

弊社を連絡する

関連リンク

トップ試験