JN0-101 無料問題集「Juniper Networks Certified Internet Associate, Junos (JNCIA-Junos)」

（A）/var/tmp/

（B）/config/

（C）/var/config/saved/

（D）/var/home/user/

（A）IPsec

（B）TACACS+

（C）RADIUS

（D）KERBEROS

（A）It is used to determine the preferred path to a given destination.

（B）It is used to select which routing table to use for forwarding.

（C）It is used to select the best route between multiple equal-cost paths.

（D）It is used as a tiebreaker when the same prefix is available through multiple protocols.

（A）a brief description of commands and their default values

（B）the serial number and version number of the device used to open a support case with JTAC

（C）a list of all the active hardware alarms on the device

（D）a display of the current configuration while in operational mode

（A）set date ntp 64.32.129.3

（B）set time 64.32.129.3

（C）set clock ntp 64.32.129.3

（D）set ntp time 64.32.129.3

（A）96

（B）90

（C）118

（D）110

（A）01100000

（B）11010100

（C）11010000

（D）11101010

（A）You must have a console connection.

（B）You must press the Enter key so that you can boot into single-user mode.

（C）You cannot set the console port to an insecure mode.

（D）When prompted to enter the full pathname of the shell, you must press the Enter key.

（A）Dynamic routing typically requires less time to implement than static routing in a large network.

（B）Dynamic routing provides redundant IP addresses for end-user devices, unlike static routing.

（C）Dynamic routing provides DNS services along with IP connectivity; static routing does not.

（D）Dynamic routing requires no initial user configuration, unlike static routing.

（A）The forwarding table is stored in the control plane and in the forwarding plane.

（B）The forwarding table contains both active and inactive routes.

（C）The forwarding table can contain only a single next hop per destination.

（D）The forwarding table is stored in the control plane only.