JN0-351無料問題集「Juniper Enterprise Routing and Switching, Specialist (JNCIS-ENT)」

質問 1

Click the Exhibit button.

R1 was started at 4:00 PM. R2 and R3 were started at 6:00 PM. R4 was started at 10:00 PM. All routers are in Area 0 and there are no point-to-point links.
Referring to the exhibit, which router is the designated router?

（A）R1

（B）R4

（C）R3

（D）R2

正解：B 解答を投票する

質問 2

You deployed a new EX Series switch with DHCP snooping enabled and you do not see any entries in the snooping databases for an interface. Which two Juniper configurations for that interface caused this issue?
(Choose two.)

（A）The interface is configured as a disabled port.

（B）Dynamic ARP inspection is enabled on the interface.

（C）MAC limiting is enabled on the interface.

（D）The interface is configured as a trunk port.

正解：A、D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 3

Which two statements are correct about tunnels? (Choose two.)

（A）Tunnel endpoints must have a valid route to the remote tunnel endpoint.

（B）BFD cannot be used to monitor tunnels.

（C）Tunnels add additional overhead to packet size.

（D）IP-IP tunnels are stateful.

正解：A、C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 4

Which two statements about BGP facilitate the prevention of routing loops within an autonomous system?
(Choose two.)

（A）IBGP sessions must be configured as a logical full mesh.

（B）IBGP sessions must be configured as a physical full mesh.

（C）Routes learned from IBGP neighbors are not readvertised to other IBGP neighbors.

（D）Routes learned from IBGP neighbors are only advertised to other IBGP neighbors.

正解：A、C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 5

Exhibit

You are troubleshooting an issue where traffic to 192.168.10.0/24 is being sent to R1 instead of your desired path through R2.
Referring to the exhibit, what is the reason for the problem?

（A）R2 ' s route is not the best path due to loop prevention.

（B）R1 ' s route is the best path due to a higher local preference

（C）R2 ' s route is not the best path due to a lower origin code.

（D）R1 ' s route is the best path due to the shorter AS path.

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 6

You are attempting to configure the initial two aggregated Ethernet interfaces on a router but there are no aggregated Ethernet interfaces available.
In this scenario, which configuration will enable these interfaces on this router?

（A）

（B）

（C）

（D）

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

JN0-351 無料問題集「Juniper Enterprise Routing and Switching, Specialist (JNCIS-ENT)」

弊社を連絡する

関連リンク

トップ試験