JN0-352 無料問題集「Juniper Enterprise Routing and Switching, Specialist (JNCIS-ENT)」

（A）R1 will modify the next-hop attribute in prefixes advertised to AS 65501

（B）R1 will modify the AS path attribute in prefixes advertised to AS 65501

（C）R1 will modify the originator ID attribute in prefixes advertised to AS 65501

（D）R1 will modify the cluster list attribute in prefixes advertised to AS 65501

（A）Peer 10.32.1.2 is configured for AS 63645.

（B）The R1 is configured for AS 65400.

（C）The BGP session is not established.

（D）The routers are exchanging IPv4 routes.

（A）Ensure that the first LAG interface name is ae1.

（B）Ensure that the first LAG interface name is ae0.

（C）Ensure that LAG is enabled on the chassis.

（D）Ensure that LAG is enabled on each member interface.

（A）You can only apply firewall filters to Layer 2 traffic on an EX Series switch.

（B）You can deploy both stateless and stateful firewall filters on an EX Series switch.

（C）You can apply firewall filters to both Layer 2 and Layer 3 traffic on an EX Series switch.

（D）You can deploy only stateless firewall filters on an EX Series switch.

（A）blocking

（B）listening

（C）flooding

（D）learning

（A）The virtual IP address must match on all participating devices

（B）The VRRP group number must match on all participating devices

（C）The VRRP group number must be unique on all participating devices

（D）The virtual IP address must be unique on all participating devices

（A）preamble of Ethernet packet

（B）ether type details

（C）MAC learned time

（D）interface details

（A）Tunnel endpoints must have a valid route to the remote tunnel endpoint.

（B）BFD cannot be used to monitor tunnels.

（C）Tunnels add additional overhead to packet size.

（D）IP-IP tunnels are stateful.