JN0-362無料問題集「Juniper Service Provider Routing and Switching, Specialist (JNCIS-SP)」

質問 1

Which two functions are performed by the OSPF designated router? (Choose two.)

（A）It forms adjacencies with all the other OSPF routers on the link

（B）It designates some routers as inactive when not needed

（C）It advertises link-state information to the AS

（D）It chooses the backup designated router

正解：A、C 解答を投票する

質問 2

Which two high availability features preserve interface and kernel information during reconvergence? (Choose two.)

（A）nonstop bridging (NSB)

（B）graceful Routing Engine switchover (GRES)

（C）nonstop active routing (NSR)

（D）graceful restart (GR)

正解：B、C 解答を投票する

質問 3

Which statement is true about an OSPF broadcast link?

（A）All routers form an adjacency only with the DR

（B）All routers form an adjacency only with the BDR

（C）All routers form an adjacency with all other routers

（D）All routers form an adjacency with both the DR and BDR

正解：D 解答を投票する

質問 4

Which statement correctly describes a characteristic of IPv6 unicast addressing?

（A）Only one loopback address exists, ::1/128.

（B）Link-local addresses are in the range of FE00::/12.

（C）Global addresses are in the range of 2002::/16.

（D）Link-local addresses are in the range of FF00::/8.

正解：A 解答を投票する

質問 5

Click the Exhibit button.

In the network shown in the exhibit, all switches are configured with the default STP root bridge priority, and Switch A has been selected as root. You recently added the older Switch D into the network as an access switch, and notice it has taken over as root.
Which configuration would solve this problem?

（A）Option D

（B）Option B

（C）Option C

（D）Option A

正解：C 解答を投票する

質問 6

You are asked to change the default TTL handling behavior on your Junos device to ensure that the RSVP- signaled LSPs in your MPLS network cannot be mapped.
Which configuration should be performed to accomplish this task?

（A）Configure the no-decrement-ttl parameter for each LSP on the egress device

（B）Configure the no-propagate-ttl parameter for each LSP on the egress device

（C）Configure the no-decrement-ttl parameter for each LSP on the ingress device

（D）Configure the no-propagate-ttl parameter for each LSP on the ingress device

正解：B 解答を投票する

質問 7

Click the Exhibit button.

Referring to the exhibit, which statement is correct?

（A）R2 is an ABR

（B）R1 is a backbone router

（C）R1 is an ABR

（D）R2 is an ASBR

正解：A 解答を投票する

JN0-362 無料問題集「Juniper Service Provider Routing and Switching, Specialist (JNCIS-SP)」

弊社を連絡する

関連リンク

トップ試験