NS0-171無料問題集「Network Appliance FlexPod Implementation and Administration」

質問 1

You have a NetApp clustered Data ONTAP storage system and vSphere 6 cluster. You discover that VMware VAAI for NFS is not showing as enabled on one of the five ESXi hosts in your vSphere cluster.
In this scenario, what must you do to enable VAAI for NFS on that ESXi host?

（A）Enable VMware vStorage for NFS on the NetApp SVM.

（B）Install the NetApp NFS Plug-in for VMware VAAI on the ESXi host.

（C）Set the DataMover. HardwareAcceleratedInit advanced setting to 0 on the ESXi host.

（D）Enable NFSv3 on the storage system.

正解：D 解答を投票する

質問 2

Which three management tools would you use to configure the NetApp storage component in a FlexPod Datacenter solution? (Choose three.)

（A）NetApp Virtual Storage Console (VSC) for VMware Sphere

（B）NetApp OnCommand System Manager

（C）Cisco UCS Director

（D）NetApp OnCommand Perfromance Manager

（E）Cisco UCS Central

正解：A、B、E 解答を投票する

質問 3

Click the Exhibit button.

An iSCSI SAN boot is not working for a new Cisoc UCS service profile.
The new vNIC template was created using the settings shown in the exhibit.
What should you do to make iSCSI SAN boot work?

（A）Specify a QoS policy.

（B）Set the iSCSI-A-VLAN as the "Native VLAN".

（C）Change the MAC pool to "<not set>".

（D）Change the vNIC template to type "Initial Template".

正解：A 解答を投票する

質問 4

You are creating the Gold Master Boot LUN for Windows 2012 R2 Hyper-V hosts.
In this scenario, which three steps are needed to ensure that all Hyper-V hosts will work as desired? (Choose three.)

（A）Enter in the Windows license key to activate Windows before cloning the LUN.

（B）Use a temporary service profile to install and configure the OS.

（C）Use Sysprep to prepare the operating system for duplication.

（D）Disassociate the service profile before cloning the LUN.

（E）Map all Hyper-V hosts to the same Gold Master Boot LUN for consistency.

正解：A、B、E 解答を投票する

質問 5

Which two operating modes are available with the Nexus 9000 Series switches? (Choose two.)

（A）Cisco NX-OS

（B）Cisco IOS

（C）Cisco ACI

（D）Cisco IOS EX

正解：A、C 解答を投票する

質問 6

After deploying a FlexPod solution, which tool would you use to validate a successful installation?

（A）Hardware Universe

（B）System Manager

（C）Config Advisor

（D）UCS Manager

正解：B 解答を投票する

NS0-171 無料問題集「Network Appliance FlexPod Implementation and Administration」

弊社を連絡する

関連リンク

トップ試験