NSE6_FSW-7.2無料問題集「Fortinet NSE 6

質問 1

How does FortiGate handle configuration of flow tracking sampling if you export the settings to a managed FortiSwitch stack with sampling mode set to perimeter is true?

（A）FortiGate configures and enables egress sampling on all management interfaces.

（B）FortiGate configures FortiSwitch to perform ingress sampling on all switch interfaces, except ICL and ISL interfaces.

（C）FortiGate configures FortiSwitch to perform ingress sampling on all switch interfaces.

（D）FortiGate configures and enables flow sampling on FortiSwitch but does not change existing sampling settings of interfaces.

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 2

Refer to the exhibit.

Which two statements best describe what is displayed in the FortiLink debug output shown in the exhibit? (Choose two.)

（A）FortiSwitch is ready to push its new hostname to FortiGate.

（B）FortiSwitch is in a waiting state to join the stack group on FortiGate.

（C）FortiSwitch is discovered and authorized by FortiGate.

（D）FortiSwitch is sending FortiLink heartbeats to FortiGate.

正解：C、D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 3

Which interfaces on FortiSwitch send out FortiLink discovery frames by default in order to detect a FortiGate with an enabled FortiLink interface?

（A）The ports with auto-discovery enabled by default are dependent upon the FortiSwitch model.

（B）All ports have auto-discovery enabled by default.

（C）The last four switch ports on FortiSwitch have auto-discovery enabled by default.

（D）No ports are enabled by default for auto-discovery. This must be configured under config switch interface.

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 4

Refer to the configuration:

Which two conditions does FortiSwitch need to meet to successfully configure the options shown in the exhibit above? (Choose two.)

（A）The split port can be assigned to a native VLAN.

（B）The FortiSwitch model is equipped with a maximum of 54 interfaces

（C）The Dort full speed prior to the split was 100G QSFP+.

（D）FortiSwitch would need to be rebooted.

正解：B、D 解答を投票する

質問 5

Which is a requirement to enable SNMP v2c on a managed FortiSwitch?

（A）Enable an SNMP v3 to handle traps messages with SNMP hosts.

（B）Create an SNMP user to use for authentication and encryption.

（C）Configure SNMP agent and communities.

（D）Specify an SNMP host to send traps to.

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 6

What feature can network administrators use to segment network operations and the administration of managed FortiSwitch devices on FortiGate?

（A）Multi-chassis link aggregation trunk

（B）FortiGate multi-tenancy

（C）FortiLink split interface

（D）FortiGate clustering protocol

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

NSE6_FSW-7.2 無料問題集「Fortinet NSE 6 - FortiSwitch 7.2」

弊社を連絡する

関連リンク

トップ試験