NSE7_SDW-6.4無料問題集「Fortinet NSE 7

質問 1

Refer to Exhibit:

Based on the exhibit, which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules, among the member interfaces?

（A）All traffic from a source IP is sent to the same interfaces.

（B）All traffic from a source IP Is sent to the most used Interface.

（C）All traffic from a source IP to a destination IP is sent to the least used interface.

（D）All traffic from a source IP to a destination IP Is sent to the same interface.

正解：D 解答を投票する

質問 2

Which diagnostic command can you use to show the SD-WAN rules interface information and state?

（A）diagnose sys sdwan service.

（B）diagnose sys sdwan route-tag-list.

（C）diagnose sys sdwan member.

（D）diagnose sys sdwan neighbor.

正解：A 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 3

Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two )

（A）FEC transmits the original payload in full to recover the error in transmission.

（B）FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss

（C）FEC improves reliability which overcomes adverse WAN conditions such as noisy links.

（D）FEC transmits additional packets as redundant data to the remote device.

（E）FEC is useful to increase speed at which traffic is routed through IPsec tunnels.

正解：C、D 解答を投票する

質問 4

Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?

（A）get router info routing-table

（B）diagnose debug application ike

（C）get ipsec tunnel list

（D）diagnose sys virtual-wan-link service

正解：B 解答を投票する

質問 5

Refer to the exhibit.

Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)

（A）The number of simultaneous connections among all source IP addresses can exceed 5 connections.

（B）The number of simultaneous connections allowed for each source IP address can exceed 5 connections.

（C）The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.

（D）The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.

正解：A、C 解答を投票する

質問 6

Refer to exhibits.

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)

（A）The implicit rule overrides all other rules because parameters widely cover sources and destinations.

（B）The initial session of an application goes through a learning phase in order to apply the correct rule.

（C）SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom.

（D）The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces.

正解：B、C 解答を投票する

質問 7

Refer to exhibits.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

（A）The dead member interface stays unavailable until an administrator manually brings the interface back.

（B）FortiGate has not received three consecutive requests from the SLA server configured for port2.

（C）Port2 needs to wait 500 milliseconds to change the status from alive to dead.

（D）Static routes using port2 are active in the routing table.

正解：B 解答を投票する

質問 8

Which three protocols are available only on the command line to configure as performance SLA status check? (Choose three.)

（A）tcp-echo

（B）udp-echo

（C）smtp

（D）twamp

（E）icmp

正解：A、B、D 解答を投票する

NSE7_SDW-6.4 無料問題集「Fortinet NSE 7 - SD-WAN 6.4」

弊社を連絡する

関連リンク

トップ試験