ST0-250 無料問題集「Symantec Messaging Gateway 10.5 Technical Assessment」

（A）runs expunger agents for the quarantine

（B）downloads virus definitions

（C）hosts a web server

（D）provides quarantine storage for messages

（E）filters the message stream

（A）Pause the MTA

（B）Flush all delivery queues

（C）Do not accept incoming messages

（D）Pause message scanning and delivery

（A）configure an LDAP source with Authentication and Address Resolution functions

（B）add "Hold message in Spam Quarantine" action to Local Bad Senders domains

（C）check the option "Enable end-user settings for this policy group"

（D）configure an LDAP source with Authentication and Recipient Validation functions

（E）configure an LDAP source with Authentication and Routing functions

（A）Domain mapping

（B）Address aliasing

（C）Content filtering

（D）Address masquerading

（A）Symantec DLP will quarantine messages that violate established policies,blocking it from SMG.

（B）Symantec DLP will use TLS to send a notification message to the SMG server for any content violations.

（C）Symantec DLP will add information into the message that can be interpreted by SMG and then send it to SMG via SMTP.

（D）Symantec DLP uses the ICAP protocol to indicate if a message is clean,or if it violated any defined policies.

（A）Symantec Messaging Gateway must be configured in scanner-only mode.

（B）Symantec Messaging Gateway must be configured with two network interfaces.

（C）Symantec Messaging Gateway must be the first SMTP hop into the network.

（D）Symantec Messaging Gateway must use a virtual IP address.

（A）Message Audit log

（B）Filtering Precedence Exception report

（C）Filtering Policy report

（D）Incident Match log