VNX301無料問題集「Versa Networks Versa Certified SD-WAN Specialist (VNX300)」

質問 1

A tenant has two internet circuits and one LTE backup circuit. The forwarding profile lists the internet circuits with priority 1 and LTE with priority 2. The next-hop selection method is Load Balance. What is the expected behavior while both internet circuits are healthy?

（A）Sessions are distributed across the two priority-1 internet circuits.

（B）Traffic is replicated across all three circuits.

（C）The branch drops traffic until one circuit fails.

（D）All sessions are forced to LTE because it has the highest number.

正解：A 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 2

A new SD-WAN branch has completed factory-default onboarding and Versa Director has pushed the staging configuration. After reboot, the branch still tries to connect to the staging server instead of the Controller.
Which configuration item is most likely incorrect or missing in the stage-two configuration?

（A）Analytics log collector IP address

（B）Controller IP address in the IPsec profile remote IP field

（C）Tenant LAN DHCP pool

（D）URL filtering profile

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 3

Examine the exhibit below.
You are configuring an IPsec tunnel towards a non-SD-WAN site over the INETTransport-VR. The site IP address is 10.1.1.1. This tunnel is for traffic between the 192.168.100.0/24 and the 192.168.200.0/24 LAN networks. The tunnel does not establish.
Referring to the exhibit, which statement is correct?

（A）The Routing Instance should be changed to global.

（B）A precedence higher than 0 needs to be set.

（C）The Policy Configuration is missing an additional policy with the subnets swapped.

（D）The Tunnel Routing Instance is incorrect.

正解：D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 4

A branch device has completed Stage 3 onboarding. Which set of tunnels or sessions should exist after the device becomes fully operational in the customer SD-WAN network?

（A）Only an HTTPS session between the branch and Director

（B）GRE-only tunnels between all branches without IPsec

（C）Only a BGP session between the branch and Analytics

（D）IKE and IPsec sessions between the branch and Controller, and VXLAN and ESP sessions between branches

正解：D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 5

A branch uses a template variable for the WAN VLAN ID. During deployment, Branch-A receives VLAN
100 and Branch-B receives VLAN 200 from device bind data while using the same template. Which statement is correct?

（A）This is impossible because all devices using a template must share identical VLAN IDs.

（B）The Controller automatically rewrites VLAN IDs after IPsec comes up.

（C）The device template must be duplicated for each branch.

（D）This is expected because template variables allow unique per-device values.

正解：D 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 6

A customer has purchased 10 Versa SD-WAN licenses. In this scenario, which statement is correct?

（A）The customer's SD-WAN CPE will subjugate to Versa Director using ZTP; afterward, the license subscriptions will be managed by Versa Director.

（B）The customer's CPE will subjugate to Versa Controller using ZTP; afterward, the licenses and license subscriptions will be managed by Versa Controller.

（C）The customer will be provided 10 Versa SD-WAN soft licenses.

（D）The customer will be provided 10 Versa SD-WAN CPEs loaded with a Versa SD-WAN license.

正解：A 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 7

Examine the CLI output in the exhibit.

You are reviewing the OSPF adjacency on a VOS CPE, and the output is shown in the exhibit. In this scenario, what is the probable cause of the OSPF adjacency issue?

（A）There is an OSPF area mismatch between the peers.

（B）There is an interface MTU mismatch between the OSPF peers.

（C）There is a filter configured on the peer that is dropping 224.0.0.5 traffic.

（D）There is no bidirectional communication between the OSPF peers.

正解：B 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

VNX301 無料問題集「Versa Networks Versa Certified SD-WAN Specialist (VNX300)」

弊社を連絡する

関連リンク

トップ試験