101-01 無料問題集「Riverbed Certified Solutions Associate」

（A）HSRP or VRRP gateways

（B）SteelHead Mobile optimization

（C）Simplified Routing

（D）Server-side initiated connections

（E）Path Selection

（A）Insufficient bandwidth

（B）Daylight Savings Time settings

（C）Transport protocol inefficiencies

（D）Proxy ARP

（E）Application protocol chattiness

（A）Expand disk capacity

（B）Clean the datastore

（C）No action is required

（D）Disconnect all users

（E）Insert a USB key for extra storage

（A）Increase throughput of connections

（B）Failover for Steelhead appliances

（C）Centralize reporting and management

（D）No single point of failure in a redundant Steelhead appliance deployment

（E）Redirect traffic to a pool of Steelhead appliances

（A）Endpoint policy

（B）A single policy for all the above

（C）Security policy

（D）Acceleration policy

（A）The Interceptor tunnels them over the connection using port 7850 to the SteelHeads.

（B）They are GRE-encapsulated by the Interceptor, and forwarded using the SteelHead IP.

（C）The Interceptor applies the MAC address of the SteelHead's in-path interface and forwards at layer 2.

（D）Destination NAT is performed on the Interceptor, changing the destination IP adress from the client IP to the SteelHead's IP.

（E）The server sees the IP address of the SteelHeads in-path interface as its client, so there is no need for the Interceptor to forward it.

（A）Concurrent usage

（B）Steelhead Mobile does not use a licensing model as long as you do not exceed the capacity of the SMC

（C）Per seat

（D）Hybrid per seat/concurrent usage

（A）Connection forwarding (using port 7850 for neighbor relationships) on Steelhead appliances

（B）Pass-through rules to minimize overlapping opens

（C）Automatic peering (using enhanced auto-discovery) enabled on Steelhead appliances

（D）Fixed-target rules directed to port 7850 of all branch office Steelhead appliances

（A）Partially warm, the Steelhead appliances only need to learn the new data

（B）Cold, the data now travels in another direction so the Steelhead appliance needs to relearn the data

（C）Cold, the file has been changed to the file needs to be stored again

（D）Warm, all the data has been seen by the Steelhead appliances before

（E）Warm, the transaction prediction module of the Steelhead appliance can detect the application and accelerate the transfer

（A）Cloud portal is troubleshooting resource to which all SteelHeads report data.

（B）Cloud Portal collects data reduction statistics for SaaS applications.

（C）Cloud portal is a resource where the SaaS certificates are managed.

（D）Cloud Portal collects data reduction and netflow statistics for SaaS applications.

（E）Cloud portal is a resource that registers SteelHeads, allowing them to use SteelHead SaaS.

（A）Load balancing rules

（B）Optimization rules

（C）Peering rules

（D）TCP rules

（E）Acceleration policies

（F）In-path rules

（A）Reports > Data Store Status

（B）Reports > Data Store Cost

（C）Reports > Data Store Disk Load

（D）Reports > Data Store Hit Rate

（A）Latency detection

（B）Fixed-target rule

（C）In-path rule

（D）Adapter based configuration

（A）steelheadcmc

（B）cmcriverbed

（C）cmcsteelhead

（D）riverbedcmc

（A）Riverbed integrating Operating System

（B）Riverbed interact Operations Shares

（C）Riverbed Open Standards

（D）Riverbed is Orange Shamrocks

（E）Riverbed Optimization System

（F）Riverbed is Outstandingly Simple

（G）Riverbed Internet Optimization System

（H）Riverbed Intranet Optimization System

（A）The server must be ignoring or resetting connections on port 139, so the client tries again on port 445.

（B）The server must be ignoring or resetting connections on port 445, so the client again on port 139.

（C）Clients often try to connect on port 139 and 445 simultaneously for compatibility reasons. Once one connection is accepted, the other gets reset.

（D）This is because SMB2 and CIFS optimization are both enabled on the SteelHeads.

（A）600 MB

（B）4.8 TB

（C）3.6 TB

（D）1.2 TB

（E）0 MB

（A）Token Ring

（B）None of the above

（C）Crossover

（D）Straight-through