DES-1721無料問題集「EMC Specialist - Implementation Engineer, SC Series」

質問 1

Which datapage size options are available for SC Series arrays?

（A）512 KB, 1 MB, and 2 MB

（B）1 MB, 2 MB, and 4 MB

（C）512 KB, 2 MB, and 4 MB

（D）1 MB, 4 MB, and 8 MB

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 2

A SC5020 has been installed and it is using front-end SAS. There is a problem on Server A and Server B during Controller failover. Each server has a connection in Fault Domains 1 and 2.
What is wrong?

（A）Servers must have all connections in a single Fault Domain

（B）SAS switch configuration issue

（C）SC5020 does not support SAS as the front-end

（D）Asymmetric Logical Unit Access (ALUA) is not properly configured

正解：B 解答を投票する

質問 3

A customer wants to configure their host to use MPIO with Storage Center. What is a requirement for it to work?

（A）At least two FC or iSCSI ports per host

（B）All host ports must be connected to a single Fault Domain

（C）MPIO is only supported on Linux OS

（D）This is a licensed feature

正解：A 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 4

When planning the necessary Bandwidth for Remote Instant Replay what needs to be considered?

（A）Volume QoS

（B）Mismatched MTU

（C）Snapshot frequency

（D）FC Zoning between sites

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 5

Which utility is used to discover and configure an uninitialized SCv2000 array?

（A）DSM Client

（B）DSM Collector

（C）PuTTy

（D）Remote Client

正解：A 解答を投票する

質問 6

Which SC Series array feature allows all front-end ports to act as active data paths?

（A）Legacy Port Mode

（B）Virtual Port Mode

（C）Dual Fabric

（D）ALUA

正解：B 解答を投票する

質問 7

What information is required to configure an iSCSI initiator?

（A）VLAN tag, port speed, Multicast control setting

（B）MAC address, VLAN broadcast address

（C）Alias, Zone, Zone Config name

（D）Target IP Address, subnet, gateway

正解：D 解答を投票する

質問 8

A customer has asked you to confirm whether their volumes will remain online even after a controller failure. What is the correct sequence of steps to perform a controller failover test?

正解：

質問 9

A customer has two production sites with one storage administrator at each site. The customer wants to replicate data between their SC9000 storage arrays. Each administrator uses a workstation with the Dell Storage Manager Client to manage their respective system. Now, the CEO wants data replicated between both sites.
What is the first step to configure replication between sites?

（A）Initially sync data with USB hard drives

（B）Configure an iSCSI network over WAN

（C）Create a QoS node in Dell Storage Manager Client

（D）Install Dell Storage Manager Data Collector

正解：D 解答を投票する

質問 10

What is the correct sequence of steps to enable MPIO on a Microsoft Windows 2012 Server?

正解：

DES-1721 無料問題集「EMC Specialist - Implementation Engineer, SC Series」

弊社を連絡する

関連リンク

トップ試験