DES-5121無料問題集「EMC Specialist - Implementation Engineer, Campus Networking」

質問 1

What happens when a match is found for an ACL with 15 entries?

（A）All packets which match that entry are forwarded

（B）Action from that entry is performed and the ACL is exited

（C）All packets which match that entry are dropped

（D）Action from that entry is performed and the rest of the entries in the ACL are processed

正解：B 解答を投票する

質問 2

What is the interaction between CDP, ISDP, and LLDP when communicating configuration information from a Dell EMC Campus networking switch to a Cisco VoIP phone?

（A）N-Series switches can be configured to use only CDP to communicate configuration information with Cisco devices

（B）N-Series switches can be configured to use ISDP or CDP to communicate configuration information with Cisco devices

（C）N-Series switches can be configured to use LLDP or CDP to communicate configuration information with Cisco devices

（D）N-Series switches can be configured to use ISDP or LLDP to communicate configuration information with Cisco devices

正解：D 解答を投票する

質問 3

A user's workstation has an IP phone connected to a Dell EMC N-Series switch.
What is the recommended number of VLANs that should be configured on the switch port?

（A）3

（B）1

（C）2

（D）0

正解：C 解答を投票する

質問 4

You are tasked with deploying a single Dell EMC N-Series switch with a 2-port port-channel to uplink to an existing upstream switch. The following reflects the upstream switch configuration:
N4032F#show running-config interface tengigabitethernet 1/0/5
channel-group 1 mode on
N4032F#show running-config interface tengigabitethernet 1/0/6
channel-group 1 mode on
Which type of port-channel should be configured to successfully uplink?

（A）Passive

（B）Static

（C）MLAG

（D）Active

正解：B 解答を投票する

質問 5

In a PoE environment, what information does the Network Policy TLV exchange between the PSE and PD?

（A）DSCP Value, Required Power, and IEEE Priority

（B）Required Power, VLAN ID, and DSCP Value

（C）VLAN ID, IEEE Priority, and DSCP Value

（D）IEEE Priority, Required Power, and VLAN ID

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 6

A network administrator has configured a 4-port port-channel between two Dell EMC Campus networking switches. The physical interfaces show as administratively up and operationally up on both switches. However, the port-channel shows as operationally up on Switch A and operationally down on Switch B.
What is a potential reason for the inconsistent port-channel state?

（A）Switch A is configured using channel-group # mode on and Switch B is configured using channel- group # mode auto

（B）Ports in the port-channel on Switch A are all the same speed but the ports in the port-channel on Switch B are a mix of speeds

（C）Switch A is configured to use dynamic port-channels and Switch B is configured to use static port- channels

（D）N-Series supports a maximum number of physical interfaces that can be included in port-channels on a per-device basis

正解：A 解答を投票する

DES-5121 無料問題集「EMC Specialist - Implementation Engineer, Campus Networking」

弊社を連絡する

関連リンク

トップ試験