JN0-1362無料問題集「Juniper Service Provider Design Specialist (JNCDS-SP)」

質問 1

Exhibit.

Within ISP E, R1 is load-balancing traffic destined to ISP D over the R1-R2-R5 and R1-R4-R5 paths. At some point, a link degradation event occurs in the network as shown in the exhibit. You want R1 to rapidly learn of the path failure.

（A）Adjust the OSPF hello timer to a subsecond value between R4 and R5.

（B）Adjust the OSPF hello timer to a subsecond value between R1 and R4.

（C）Enable Bidirectional Forwarding Detection between R4 and R5.

（D）Enable Bidirectional Forwarding Detection between R1 and R4.

正解：C 解答を投票する

質問 2

Which RFC standards-based feature allows for customer-specific configuration parameters to be passed between RADIUS and a BRAS?

（A）vendor-specific attributes

（B）DHCP options

（C）LSA

（D）DHCPv6 options

正解：A 解答を投票する

質問 3

Exhibit.

Referring to the exhibit which type of IPsec VPN should be used to create the desired topology?

（A）Group VPN

（B）AutoVPN

（C）fully meshed VPN

（D）hub-and-spoke VPN

正解：A 解答を投票する

質問 4

Which security implementation does Juniper Networks recommend for all core routers in a service provider network?

（A）unified threat management

（B）stateless loopback firewall filter

（C）application firewall

（D）intrusion and detection prevention

正解：B 解答を投票する

質問 5

Your customer is deploying a multi-tenant data center and needs help with the WAN edge design.
What are two main design considerations for this environment? (Choose two)

（A）support for data collection and analysis

（B）support for unified threat management

（C）support for Virtual Chassis Control Protocol

（D）support for Network Address Translation

正解：A、D 解答を投票する

質問 6

You are preparing to purchase WAN services from a service provider You are required to protect all Layer 2 and higher traffic from injection wiretapping, man-in-the-middle, and playback type attacks.
Which solution would satisfy this requirement?

（A）Use Layer 3 VPN services from the service provider

（B）Use MACsec between locations.

（C）Use Layer 2 VPN services from the service provider.

（D）Use IPsec between locations.

正解：D 解答を投票する

質問 7

You 2 VPN services to interconnect three of their sites.

（A）It maintains all customer Layer 3 routing information.

（B）It selects the appropriate circuit on which to traverse the Layer 2 VPN.

（C）In this scenario, what are two functions of the CE device? (Choose two.)

（D）It maintains an MP-BGP session to all other sites to exchange route information for the Layer 2 VPN.

（E）It maintains all MPLS LSPs between the sites.

正解：A、E 解答を投票する

質問 8

You are developing a CoS policy for a service provider core network that In this scenario, which three statements are correct? (Choose three.)

（A）Core routers should use a consistent CoS configuration across the network.

（B）Core routers should use policers to ensure that customer traffic does not exceed allowed bandwidth.

（C）Core routers should use shapers to ensure that customer traffic does not exceed allowed bandwidth.

（D）Core routers should use the DSCP markings already set on ingress traffic.

（E）Core routers should use a common set of per-hop behaviors.

正解：B、D、E 解答を投票する

質問 9

Your applications are migrating from a legacy data center to an EVPN over a VXLAN-based VM environment. A few critical legacy applications not support this environment and must remain on bare metal servers and the applications must be able to access the Internet.
What must be included in the VXLAN design to satisfy these requirements?

（A）SR-IOV

（B）VTEP tunneling

（C）VXLAN gateway

（D）nested VM capability

正解：C 解答を投票する

解説: (JPNTest メンバーにのみ表示されます)

質問 10

Which Juniper Networks platform automates the orchestration of compute, storage, and networking resources to create and manipulate OpenStack clouds?

（A）Contrail

（B）NorthStar

（C）RingMaster

（D）WANDL

正解：A 解答を投票する

JN0-1362 無料問題集「Juniper Service Provider Design Specialist (JNCDS-SP)」

弊社を連絡する

関連リンク

トップ試験