Scenario 3:
After resolving numerous connectivity Issues throughout the various branch sites, connectivity between applications and users is finally present- The network administrator is informed (hat during certain tests, applications are not performing as they are expected to. Users report that call quality has not fully improved and that some of their calls either drop or have poor voice quality where the conversation is breaking up. Other users are noticing that file transfers are slower than expect. A group of users from a few sites have reported slowness in accessing internal and external applications.
Exhibit.

Which metrics can a network administrator verify in the QoE screen to determine the overall health of Underlay and Overlay?

• A. Packet Loss, Latency, Speed.
• B. Jitter, Speed, Latency.
• C. Jitter Packet Loss, Speed.
• D. Jitter, Packet Loss, Latency.

Scenario 2:
After completing the branch activation activities for all required branches, the network administrator attempts to test connectivity between the various branches and between the hubs and branches. The administrator notices a lack of connectivity despite being certain that configurations have been complete. The administrator also observed that several users are reporting intermittent connectivity to some of the applications they are accessing. Other users are reporting no access to these applications. Other users at some of the branches claim they cannot get to certain public resources. The administrator wants to ensure that all sites can talk to each other and all resources are accessible.
Exhibit.

Users at the London site are complaining of various intermittent issues around websites not loading, or applications being remotely accessed disconnecting sporadically and reconnecting after a few minutes. The network administrator does not see anything strange on the Edge overview page and decides to check if the CPU or memory have been hitting close to 100%.
Where should the administrator verify this information?

• A. In the VCO > Monitor > Click London_Site01 > Click the System Tab
• B. In the VCO > Monitor > Alerts
• C. In the VCO > Remote Troubleshooting > Remote Actions > System Status
• D. In the VCO > Test 8c Troubleshoot > Remote Diagnostics > System Status

Scenario 2:
After completing the branch activation activities for all required branches, the network administrator attempts to test connectivity between the various branches and between the hubs and branches. The administrator notices a lack of connectivity despite being certain that configurations have been complete. The administrator also observed that several users are reporting intermittent connectivity to some of the applications they are accessing. Other users are reporting no access to these applications. Other users at some of the branches claim they cannot get to certain public resources. The administrator wants to ensure that all sites can talk to each other and all resources are accessible.
Exhibit.

Several reports have come in from branch locations indicating customers cannot reach applications being served by the hub location. The hub location has a single LAN-side port from which it should be learning dynamic routes for the subnets serving the applications.
How should the technician verify if the ports on the Edge are up and working?

• A. Look in Test & Troubleshoot under the Remote Actions and run System Health.
• B. Look under Administration and System Settings to verify if the interfaces are configured and enabled.
• C. Look in Test & Troubleshoot under the Remote Diagnostics and run Interface status.
• D. Look in Test & Troubleshoot under the Remote Diagnostics and run System Health.