試験JN0-335 トピック3 問題24 スレッド

Explanation
Cluster failovers occur when one node in a chassis cluster becomes inactive or unreachable, and the other node takes over the processing of traffic and services. To control when cluster failovers occur, you can configure two specific parameters on an SRX Series device: heartbeat-interval and heartbeat-threshold12.
Heartbeat-interval is the time interval, in milliseconds, between heartbeat messages sent by each node to the other node. The default value is 1000 ms. You can configure the heartbeat-interval value from 100 through 3000 ms1.
Heartbeat-threshold is the number of consecutive heartbeat messages that can be missed before a node is considered to be down. The default value is 3. You can configure the heartbeat-threshold value from 2 through 2551.
The combination of heartbeat-interval and heartbeat-threshold determines the failover time, which is the maximum time it takes for a node to detect the failure of the other node and initiate a failover. The failover time is calculated as follows: failover time = heartbeat-interval x heartbeat-threshold1.
For example, if the heartbeat-interval is 1000 ms and the heartbeat-threshold is 3, the failover time is
3000 ms. This means that if a node does not receive three consecutive heartbeat messages from the other node within 3000 ms, it will assume that the other node is down and initiate a failover1.
You can configure the heartbeat-interval and heartbeat-threshold parameters using the set chassis cluster redundancy-group group-id node node-id priority priority heartbeat-interval interval heartbeat-threshold threshold command1.
References:
1: Configuring Chassis Cluster Redundancy Group Properties | Junos OS | Juniper Networks
2: Example: Configuring an Active/Passive Cluster Deployment | Junos OS | Juniper Networks