300-160 無料問題集「Cisco Designing Cisco Data Center Infrastructure」

（A）The VLAN IDs must overlap in both Layer 2 domains

（B）All of the uplinks must be in one port channel to keep all of the ports active

（C）The Cisca UCS Fabric Interconnect must be in end-host mode

（D）The Cisco UCS Fabric Interconnect must be in switch mode

（A）Appliance

（B）SPAN source /destination

（C）Server

（D）Fibre Channel storage

（E）FCoE

（A）Up to 10 IP addresses can be configured to access CIMC on a server, 5 for out-of-band and 5 for inband.

（B）Up to 5 IP addresses can be configured to access CIMC on a server, 3 for out-of-band and 2 for inband.

（C）Up to 6 IP addresses can be configured to access CIMC on a server, 2 for out-of-band and 4 for inband.

（D）Up to 20 IP addresses can be configured to access CIMC on a server, 10 for out-of-band and 10 for inband.

（A）You can configure an FCoE port to be shared between the storage VDC and one other VDC.

（B）You can configure an FCoE port in any VDC

（C）You can use M-Series and F-Senes modules in the storage VOC

（D）You can forward lP traffic from the storage VDC

（A）Provide a route policy for incoming packets

（B）Provide VRF-aware services to all Layer 3 interfaces

（C）Provide Layer 3 isolation within a VDC

（D）Provide roLrting updates between Layer 3 mterfaces.

（A）NIV

（B）VM-FEX

（C）NIC teaming

（D）AdapterFEX

（E）NPIV

（A）Enable src-dst-ox-id load balancing on the MDS switches

（B）Change the MDS port-channel configuration to source-dest-port

（C）Enable src-dsi-id load balancing on the MDS switches.

（D）Upgrade the bandwidth for the devices connected to the MDS

（A）LISP

（B）VXLAN

（C）EVPN

（D）TRILL

（A）Server-to-server mode

（B）Spanning-tree collapsed mode

（C）End-host mode

（D）Switching mode

（A）It receives packets from core facing interfaces, decapsulates the LISP packets, and delivers them to local EIDs.

（B）It provides connectivity between non LISP sites and LISP sites by encapsulating non-LISP traffic destined to LISP sites.

（C）It implements ITR and ETR functionality on the same device to enable the establishment of bidirectional communication.

（D）It enables EIDs at LISP sites to successfully communicate with devices located at non-LISP sites