600-601無料問題集「Cisco Managing Industrial Networks with Cisco Networking Technologies」

質問 1

At which Layer would you use trace route to validate the path?

（A）Layer 4

（B）Layer 2

（C）Layer 1

（D）Layer 3

正解：D 解答を投票する

質問 2

Exhibit: Refer to the exhibit. CCNA.com has the industrial network shown in the exhibit. All switches are configured as layer 2 switches and are using VLAN 1 as their management VLAN. Each VLAN 1 interface has been assigned the correct IP address. What is the purpose of assigning a default gateway to SW-C switch?

（A）allows the switch to pass traffic between Host A and Host B

（B）allows connectivity between Host B and other devices in the network.

（C）allows connectivity between the VLAN 1 interface on SW-C and other devices in the network.

（D）allows connectivity between Host A and other devices in the network.

正解：C 解答を投票する

質問 3

With a Cisco IE 2000 switch, what does a power status LED indicate when it is solid green?

（A）The power status LED does not show solid green.

（B）Power is not present on the associated circuit and the power supply alarm is configured.

（C）Power is present on the associated circuit and the system is operating normally.

（D）The system is operating normally, but power is not necessarily present on the associated circuit.

（E）Power is present on the associated circuit, but there is no correlation to whether the system is operating normally.

正解：C 解答を投票する

質問 4

Exhibit: Which two statements are correct for a safe wiring installation to the terminal block of the switch or endpoint? (Choose two.)

（A）Connect the positive 24 VDC conductor to the V terminal and connect the negative 24 VDC return wire to the RT terminal.

（B）Verify that DC power is live and within 24 VDC voltage range before starting wiring.

（C）Insert a green ground wire into the terminal block that is marked RT for return.

（D）Because this is a low-voltage DC circuit, anyone can install this wiring without electrical training or qualifications.

（E）A ground wire can optionally be connected to the screw terminal on the front of the switch.

（F）Verify that the DC power circuit includes an overcurrent protective device that limits the DC current to 5 A.

正解：A、F 解答を投票する

質問 5

A router is not operating as expected and the network administrator wants to verify that the router booted using the correct IOS image. Which command should be used to determine which IOS is running on the router?

（A）show memory

（B）show startup-config

（C）show flash

（D）show config-register

（E）show version

正解：E 解答を投票する

質問 6

At which Layer would you troubleshoot a cabling issue?

（A）Layer 4

（B）Layer 2

（C）Layer 1

（D）Layer 3

正解：C 解答を投票する

質問 7

DRAG DROP

正解：

600-601 無料問題集「Cisco Managing Industrial Networks with Cisco Networking Technologies」

弊社を連絡する

関連リンク

トップ試験