JN0-681無料問題集「Juniper Data Center, Professional (JNCIP-DC)」

質問 1

Referring to the exhibit, not all routes are being exchanged by EBGP peers.

In this scenario, which BGP parameter would solve this problem?

（A）as-override

（B）mulcipach mulciple-as

（C）mulcihop

（D）mulcipach

正解：A 解答を投票する

質問 2

The MC-LAG group shown in the exhibit is providing high availability services for the directly connected servers. The backup liveness detection is applied to the ICL-PL link, however, when one of the members rebooted, there was traffic loss for a few seconds.

In this scenario, where should you apply the backup liveness detection?

（A）On the ae1 interface

（B）On the ae0 interface

（C）On the management interfaces

（D）On the ae2 interface

正解：C 解答を投票する

質問 3

Which protocol is used between VCF member devices to create a loop-free topology?

（A）LLDP

（B）RSTP

（C）MDTP

（D）VCCP

正解：D 解答を投票する

質問 4

You are implementing perimeter security for your data center. You need to inspect all traffic Layer 7 and ensure the failure of a port or device will not result in an interruption to traffic flows.
In this scenario, which design would satisfy these requirements?

（A）SRX Chassis cluster

（B）MX with MC LAG

（C）SRX using LAG

（D）QFX Virtual Chassis

正解：A 解答を投票する

質問 5

You are creating a new EVPN and are asked to selectively accept certain MAC advertisement routers from your EVPN peers using VXLAN Encapsulation.
Which statements is correct in this scenario?

（A）You can use VRF policies and route distinguisher values to filter out unwanted routes.

（B）You can use firewall filters to filters out unwanted routes

（C）You can use VBRF import policies and community values to filter out unwanted routes.

（D）You can use MAC filtering to filter out unwanted routes.

正解：C 解答を投票する

質問 6

What are the two valid types of VXLAN signaling?(Choose two.)

（A）RSTP

（B）RSVP

（C）EVPN

（D）MPLS

正解：B、C 解答を投票する

質問 7

You are troubleshooting an L3VPN that is part of an EVPN/MPLS DCI. You notice that the EVPN overlay BGP session toward 10.29.50.4 is unable to establish.

Why is the BGP session failing to establish?

（A）The vrf-table -label value is not configured in the remote PE.

（B）There is no route for 192.168.5.5 an VPN net 0.

（C）There is no route for 192.168.5.5. in inet 3.

（D）The route-distinguisher value on the local PE is incorrect

正解：C 解答を投票する

JN0-681 無料問題集「Juniper Data Center, Professional (JNCIP-DC)」

弊社を連絡する

関連リンク

トップ試験