GB0-381-ENU試験問題集でPDF問題とテストエンジン
GB0-381-ENU問題集で必ず試験合格させる
質問 211
Regarding the NSSA area of the OSPF protocol, the following statements are correct: _______
- A. Virtual links cannot pass through the NSSA area
- B. Tpe7 LSA injection is not allowed in the NSSA area
- C. Injection of Tpe3 LSA and Tpe4 LSA is not allowed in the NSSA area
- D. There can be multiple ASBRs in an NSSA area
正解: A,D
質問 212
IS-IS sends ________ messages periodically on the broadcast network type link.
- A. LSP
- B. PSNP
- C. IIH
- D. CSNP
正解: C,D
質問 213
The PBR configuration on a router is as follows.
polic-based-route pbr_a permit node 10
if-match acl 3000
apploutput-interface serial 2/0
polic-based-route pbr_a dennode 20
if-match acl 3000
Assuming that the policy has been successfully applied, how will the data flow matching Acl 3000 on the router be forwarded?
- A. Data streams matching Acl 3000 will be forwarded according to the default route
- B. Data streams matching Acl 3000 will be discarded
- C. The data flow matching Acl 3000 will not be forwarded according to the normal route
- D. Data flow matching Acl 3000 will not be forwarded according to policy routing
正解: C
質問 214
______ Use the shortest path first (SPF) algorithm.
- A. RIP
- B. BGP
- C. S-IS
- D. OSPF
正解: C,D
質問 215
Which of the following tools are route filters?
- A. ACL
- B. route-polic
- C. filter-polic
- D. Address mask
正解: A,B,C
質問 216
M In the network shown in the figure, the default next hop RTC of RTA, and the PBR configuration on RTA is as follows:
polic-based-route pbr_a permit node 10
if-match packet-length 64 100
applip-address next-hop 11.0.0.2
if-match packet-length 101 1000
applip-address next-hop 12.0.0.2
polic-based-route pbr_a dennode 20
Assuming that the strategy has been successfully applied, how will the data stream on RTA be forwarded?
- A. Messages with a message length of 64 to 100 bytes will be sent to 11.0.0.2 according to the default route
- B. Messages with a message length of 101~1000 bytes will be sent to 12.0.02 according to policy routing
- C. Messages with a message length of 64~100 bytes will be sent to 11.0.0.2.
- D. Messages with a message length of 101~1000 bytes will be sent to 11.0.02 according to the default route
正解: B,C
質問 217
PBR configuration on a router is as follows.
polic-based-route pbr_a permit node 10
if-match acl 3000
apploutput-interface serial 2/0
polic-based-route pbr_a dennode 20
if-match acl 3000
Assuming that the strategy has been successfully applied, how will the data stream configured with Acl3000 on the router be forwarded?
- A. Data streams matching Acl 3000 will be forwarded according to the default route
- B. Data streams matching Acl 3000 will be discarded
- C. Data flows matching Acl 3000 will be forwarded according to policy routing
- D. The data stream matching Acl 3000 will be forwarded according to the normal route
正解: C
質問 218
The routers RTA and RTB belong to different autonomous systems. The BGP related configuration is as follows, then between RTA and RTB ______.
RTA]
bgp 65001
timer keepalive 15 hold 45
peerRTB as-number 65001
RTB]
bgp 65002
timer keepalive 10 hold 30
peerRTA as-number 65002
- A. Cannot establish eBGP neighbor relationship
- B. The eBGP neighbor relationship can be established. The holdtime of RTA is 15s and the holdtime of RTB is 10s.
- C. Able to establish eBGP neighbor relationship, the holdtime of RTA is 30s, and the holdtime of RTB is 30s
- D. The eBGP neighbor relationship can be established. The holdtime of RTA is 45s and the holdtime of RTB is 30s.
正解: C
質問 219
RTA and RTB run the BGP routing protocol, and there is a static default route on RTA at the same time.
The correct way to import the default route in RTA into BGP is ______
- A. Configure default-route imported under RTA's BGP attempt
- B. Configure import-route static and default-route imported under RTA's BGP attempt
- C. Configure network 0.0.0.0 0.0.0.0 under RTA's BGP attempt
- D. Configure import-route static under RTA's BGP attempt
正解: B,C
質問 220
In the topology shown in the figure, perform the following configuration in RTA and RTB respectively:
RTA-ospf-1-area-0.0.0.1]network 192.168.0.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.1.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.2.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.3.0 0.0.0.255
RTA-ospf-1-area-0.0.0.1]network 192.168.4.0 0.0.0.255
RTB] acl number 2000
RTB-acl-basic-2000] rule 0 permit source 192.168.0.0 0.0.0.255
RTB-acl-basic-2000] rule 5 permit source 192.168.1.0 0.0.0.255
RTB-ospf-1-area-0.0.0.1] filter 2000 export
Then the impossible routes in the RTC routing table are _____
- A. 192.168.1.0/24
- B. 192.168.4.0/24
- C. 192.168.2.0/24
- D. 192.168.0.0/24
正解: B,C
質問 221
About the difference between system policy routing and interface policy routing. The correct statement is _________
- A. System policy routing works on both locally generated and forwarded packets
- B. Interface policy routing only affects forwarded packets, and does not affect locally generated packets
- C. System policy routing only affects local messages, and does not affect forwarded messages
- D. Interface policy routing works on both locally generated packets and forwarded packets
正解: B,C
質問 222
There are 4 routes 10.0.0.0/24, 10.0.1.0/24, 10.0.2.0/24, and 10.0.3.0/24 in the routing table.
For route aggregation, the correct route after aggregation is _________.
- A. 10.0.0.0/25
- B. 10.0.0.0/23
- C. 10.0.0.0/22
- D. 10.0.0.0/24
正解: C
質問 223
For the IS-IS protocol message interaction process, the following description is correct.
- A. NSAP is a variable length address, the longest is 160 bits, and the shortest is 64 bits
- B. In an IP network, IS-IS is carried in IP packets for interaction
- C. NSAP address is composed of IDP and DSP, with a fixed length of 160 bits
- D. IS-IS protocol packets use the NSAP address in CLNP
正解: C,D
質問 224
As shown in the figure: RTA and RTB are IBGP neighbors, and RTB and RTC are EBGP neighbors.
If the community attribute is used on the router RTA so that the route 10.10.10.0/24 on RTA can only be advertised to RTB, but cannot be forwarded to RTC through RTB, then what community attribute value should be set for 10.10.10.0/24 on RTA ?
- A. no-advertise-subconfed
- B. no-advertise
- C. no-export
- D. no-export-subconfed
正解: B,C,D
質問 225
As shown in the figure, EBGP runs between AS100, AS200, AS300, and AS400.
When AS100 receives the BGP route sent by AS400, the path sequence recorded in its AS-Path attribute is ______
- A. (100, 200, 300, 400)
- B. (400, 300.200)
- C. (400, 300.200, 100)
- D. (200, 300, 400)
正解: D
質問 226
In the IS-IS network as shown in the figure, when the routing is stable, the link between RTB and RTD is increased from the address network segment 192.168.224.0/24, then IS-IS topology ______, IP routing information ______ .
- A. No change, no change
- B. No change, change
- C. Change, change
- D. Change, no change
正解: B
質問 227
IS-IS can support network layer protocols such as _______.
- A. IPv6
- B. IPv4
- C. CLNP
- D. Ethernet
- E. TCP
正解: A,B,C
質問 228
......
合格させるH3C GB0-381-ENU試験最速合格にはJPNTest:https://www.jpntest.com/shiken/GB0-381-ENU-mondaishu