[2023年11月] 更新されたのはHP HPE6-A75問題集PDFオンラインエンジン
HPE6-A75.PDFで問題解答！サンプル問題は信頼され続けます
質問 # 41
Which protocol do Mobility Controllers (MCs) use to detect a failed Mobility Master (MM)?
- A. SNMP
- B. PAPI
- C. VRRP
- D. IPSec
正解：A
質問 # 42
Refer to the exhibit.
The network administrator wants to reduce failover time If a switch link m VIAN 100 goes down. What should the administrator do?
- A. Configure graceful restart on all of the OSPF routing devices on VLAN 100.
- B. Lower the hello timer only on the BDR of VLAN 100.
- C. Configure echo mode BFD on VLAN 100 on all OSPF routing devices on VLAN 100.
- D. Lower the dead timer on the BDR of VLAN 100.
正解：C
質問 # 43
Which statement is true about the databases in ClearPass?
- A. A Static host list can only contain a list of IP addresses.
- B. Entries in the guest user database do not expire.
- C. Entries in the guest user database can be deleted.
- D. Entries in the local user database cannot be modified.
- E. The endpoints database can only be populated by manually adding MAC addresses to the table.
正解：B
質問 # 44
Which situation requires an AOS-Switch interface to support MAC-based VLANs?
- A. The interface has an extended MAC ACL applied to it in the inbound direction, and it has multiple tagged VLAN assignments.
- B. The interface is configured to support Local MAC Authentication (LMA), authenticates endpoints against a non-default MAC group, and limits the address count to 1.
- C. The interface has an extended MAC ACL applied to it in the outbound direction, and it uses VLAN ID as one of the criteria for rules.
- D. The interface is configured to support 802.1X in user-based mode, connects to more than one endpoint at a time, and users are assigned to different dynamic VLANs.
正解：A
質問 # 45
An administrator implements a standalone controller that runs ArubaOS 8.x. Which feature should the administrator configure to optimize the RF operation for the company's WLAN?
- A. Zones
- B. Clustering
- C. ARM
- D. AirMatch
正解：D
質問 # 46
A network administrator configures V5F settings on two Aruba 2930F switches. The switches form two separate VSF fabrics. What should the administrator check?
- A. that each switch is assigned a unique VSF priority
- B. that LLDP MAD is configured on both members
- C. that the domain ID matches on both switches
- D. that the switch with the lower priority has the lower member ID
正解：D
質問 # 47
Refer to the exhibit.
Which statements accurately describe the status of the Onboarded devices in the configuration tor the network settings shown? (Select two.)
- A. They will connect to Employee_Secure SSID for provisioning their devices.
- B. They will connect to Employee_Secure SSID after provisioning.
- C. They will perform 802.1X authentication when connecting to the SSID.
- D. They will use WPA2-PSK with AES when connecting to the SSID.
- E. They will connect to secure_emp SSID after provisioning.
正解：C、E
質問 # 48
Refer to the exhibit.
Based on the configuration for the client's certificate private key as shown, which statements accurately describe the settings? (Select two.)
- A. The private key is stored in the ClearPass server.
- B. More bits in the private key will increase security.
- C. The private key for TLS client certificates is not created.
- D. More bits in the private key will reduce security.
- E. The private key is stored in the user device.
正解：B、E
解説：
Private key is mandatory and must be known only by the device, so B and C are false. More bits in the key make it more difficult to guess.
質問 # 49
A company has AOS-Switches deployed at sites with inexperienced IT staff. The main office network administrators want to track if configurations change on branch switches. What should be set up for this purpose?
- A. an auto-config server
- B. an lP SLA profile
- C. an SNMP trap
- D. an RMON alarm
正解：C
質問 # 50
OSPF is configured on an AOS-Switch, and the network administrator sets the router ID to
10.0.0.1. The administrator wants to be able to reach the switch at this ID from any location throughout the OSPF system. The administrator also needs the router ID to De stable and available, even if some links on the switch fail.
What should the administrator do?
- A. Configure 10.0.0.1 as a secondary IP address on the switch 00BM poet.
- B. Configure 10.0.0.1 on a loopback interface, and enable OSPF on that interface.
- C. Make sure that 10.0.0.1 is the IP address on the VLAN with the lowest ID.
- D. Configure 10.0.0.1 as a manual OSPF neighbor on each switch in the OSPF system.
正解：B
質問 # 51
A company has AOS-Switches, Aruba ClearPass, and Aruba Airwave. A network administrator needs to set up a new switch with the same settings found on other switches in the company.
Which action rs likely to be the most useful to perform the task?
- A. Access the Network Device view on ClearPass.
- B. Use the configuration audit tool on AirWave.
- C. View usage patterns on the switches on AirWave.
- D. View the current running config on each switch.
正解：A
質問 # 52
Refer to the exhibit.
The network administrator needs to set up BGP between the two company switches. Switch-1 and Switch-2. The BGP connection does not establish. Based on the exhibits, what does the administrator need to do to fix the issue?
- A. Set the update source for the neighbor to the local loopback interface on each switch.
- B. Enable the multihop option for the neighbor on each of the switches.
- C. Enter the network command for 10.0.0.0/24 in the router BGP mode on each switch.
- D. Enable BGP on the interfaces that the switches use to reach each other.
正解：A
質問 # 53
An AOS-Switch enforces 802.1X authentication to an Aruba ClearPass server. A user connects but cannot receive network access, even though the ClearPass administrator finds an Access- Accept for the user on this switch. The switch administrator suspects that there is an issue with the dynamic settings returned by ClearPass.
Where should the administrator look for information about these settings?
- A. in the detailed RADIUS server statistics
- B. in the interface statistics
- C. in the running-config for the interface
- D. in the details for port-access clients
正解：D
質問 # 54
Refer to the exhibit.
Switch-1 and Switch-2 connect on interface A23. The switches experience a connectivity issue. The network administrator sees that both switches show this interface as up. The administrator sees the output shown in the exhibit on Switch-1.
What is a typical issue that could cause this output?
- A. asymmetric routing introduced by a routing configuration error
- B. mismatched IP addresses on the VLAN for the link
- C. an issue with queuing, caused by mismatched QoS settings
- D. a hardware issue, such as a broken cable
正解：D
質問 # 55
What is the purpose of the captive portal URL hash key on an AOS-Switch?
- A. It authenticates guest users based on the password the users enter hi the portal.
- B. It encrypts and secures the RADIUS messages that the AOS-Switch sends to ClearPass.
- C. It specifies the captive portal URL and conceals the setting in the config.
- D. It does not let users alter the URL that redirects them to the portal.
正解：D
質問 # 56
Which is a valid policy simulation types in ClearPass? (Select three.)
- A. Posture token derivation
- B. Chained simulation
- C. Enforcement Policy
- D. Role Mapping
- E. Endpoint Profiler
正解：B、C、D
質問 # 57
Refer to the exhibit.
The network administrator wants to reduce failover time If a switch link m VIAN 100 goes down.
What should the administrator do?
- A. Configure graceful restart on all of the OSPF routing devices on VLAN 100.
- B. Lower the hello timer only on the BDR of VLAN 100.
- C. Configure echo mode BFD on VLAN 100 on all OSPF routing devices on VLAN 100.
- D. Lower the dead timer on the BDR of VLAN 100.
正解：C
質問 # 58
Refer to the exhibit.
Based on the Attribute configuration shown, which statement accurately describes the status of attribute values?
- A. Only the attribute values of title, telephoneNumber, and mail can be used in role mapping policies.
- B. Only the attribute values of department and memberOf can be used in role mapping policies.
- C. Only the attribute value of company can be used in role mapping policies, not the other attributes.
- D. The attribute values of department and memberOf are directly applied as ClearPass roles.
- E. The attribute values of department, title, memberOf, telephoneNumber, and mail are directly applied as ClearPass.
正解：D
質問 # 59
......
HP HPE6-A75問題集PDFのベストを目指すなら問題集を使おう！高得点目指すならここ：https://www.jpntest.com/shiken/HPE6-A75-mondaishu
HPE ACEP HPE6-A75試験と認定テストエンジン：https://drive.google.com/open?id=1eOLwuv1Xd3n5W_R3nWQSwf_jeG9s0DaX